Setting The Temperature Controls
•The temperature range can be set as low as 4°C or as high as 18°C to suit your specific storage
requirements.
•The standard temperature setting is 12°C.
•When setting the temperature each press on the or button the temperature setting will
increase or decrease by 1°C. When the temperature setting reaches the upper limit 18ºC or
lower limit of 4ºC, the temperature setting will not increase or decrease.
•Press the button for 3 seconds and the system will be enter the time set up. The hour
figure will flash first and each press once the or button the hour figure will increase or
decrease by 1. After 5 seconds the hour figure will stop flashing automatically and the minute
figure will flash. Each press on the or button and the minute figure will increase or
decrease by 1. After 10 seconds the system will quit the time set up. When in the time set up
temperature will not change .
•If you want to know the actual temperature, please press or for 3 seconds, the display
panel will show the actual temperature. After 5 seconds it will show the set temperature.
•Flashing word= Cabinet Temperature
Steady word = et Temperature
Note:
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will not
start.
•When you use the Wine cabinet for the first time or restart the Wine cabinet after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LCD readout. This is normal and it is due to the length of
the activation time. Once the Wine cabinet is running for a few hours everything will be back to
normal.
Function Instruction
•Temperature Memory Function
In the event of a power interruption, wine cabinet will remember the previous temperature
settings and when the power is recovered, the cabinet temperature will go back the same
setting temperature as power off.
•Open Door Alarm
When you forget close the door or the door is not closed completely, the alarm will sound after
5 minutes. Please close the door completely to avoid cold energy being lost.
•Temperature Alarm
If inner temperature is higher than 23°C, “HI” is shown in display panel, the alarm will sound
after one hour continuously. It informs that the inner temperature is too high, please check the
reason.
If inner temperature is lower than 0°C, “LO” is shown in display panel the alarm will
sound in addition the malfunction indicator will light at the same time.
