4
OPERATING YOUR WINE CABINET
AND SETTING THE TEMPERATURE CONTROL
Please use the cabinet under 5-32 ºC ambient temperature, if the ambient
temperature is higher than or lower than this temperature, it will cause the
temperature to fluctuate in the cabinet, it may not be able to reach 5-18 ºC.
¾Control System Instruction
•“Light” Button
To control the interior light, on/off.
•“Power” Button
To control this unit power, on/off. (Press and hold this button for approximately 3 seconds);
•“Up” Button
To raise (warm) the temperature in 1 ºC stages.
•“Down” Button
To lower (cool) the temperature in 1 ºC stages.
Setting The Temperature Controls
•To set the temperature, Connect the power cord to a properly grounded outlet In the
event of power interruption, the previous temperature setting is automatically erased and
it will default to a preset temperature setting of 12°C
•Set the desired cooling temperature by pressing the buttons adjacent to the “UP/DOWN"
program. Each depression of the buttons will scroll through the available temperature
setting in increments of 1 degree. The temperature selected will flash in the LED display
for approximately 5 seconds, then revert back to display the setting temperature.
•The temperature setting can be adjusted from 5°C ~18°C
¾Note
•If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will
not start.
•When you use the Wine cabinet for the first time or restart the Wine cabinet after having
been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and it is
due to the length of the activation time. Once the Wine cabinet is running for a few
hours everything will be back to normal.
