Carrier ROOM AIR CONDITIONER User manual

Before operating the unit, please read this manual thoroughly,
and keep it for future reference.
OPERATING MANUAL
Room Air Conditioner

Zeolite filter
For better air filtration and to protect your health.
Traps bacteria and prevents it from
multiplying, protecting you from disease
causing germs
Electrostatic filter
Carbon filter
Air filter
Anti-bacterial filter
Anti-bacterial filter
*Available for Remote and Heat Pump models only
5 IN 1 FILTER *
ANTI-BACTERIAL FILTER
11
Air filter
Anti-bacterial filter
** For filter care and maintenance see page 17
Evaporator
coil
Zeolite filter
Active Carbon filter
Electrostatic filter
5 STAGE FILTERS This is a 5-layered filter.
1. Air filter is very efficient in removing air-borne
particles.
2. Anti-bacterial filter removes dust, and other
tiny particles and absorbs other pollutants with
an anti-bacterial coating.
3. Zeolite filter traps and kills harmful bacteria.
4. Electrostatic filter removes minute particles of
dust and smoke. These particles get deposited
in the lungs and cause infections and other
respiratory problems.
5. An Active Carbon filter takes care the various
odours in the room environment
1

SAFETY PRECAUTIONS
!Precaution During Installation
!Precaution During Operation
PART IDENTIFICATION
!Standard (Cooling only)
!Remote (Cooling only)
!Standard (Cooling and Heating)
!Remote (Cooling and Heating)
AIR CONDITIONER OPERATION
!Standard (Cooling only)
!Standard (Cooling and Heating)
!Remote (Cooling/Cooling and Heating)
AIR CONDITIONER INSTALLATION
!Dimensions
!Installation Procedures
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
WARRANTY INFORMATION
MAINTENANCE RECORDS
3
4~10
11~14
15~16
17
18
19
19
2

Please observe the following safety precautions when using your air conditioner.
Failure or negligence in observing these safety precautions could cause fire, electrical shock or
personal injury.
Please ask your sales agent or qualified technician for the installation of your
unit. Water leakage, short circuit or fire may occur if you install the unit yourself.
Please use earth line.
Do not place the earth line near water or gas pipes, lightning-conductor, or
the earth line of telephone. Improper grounding could cause electric shock.
A circuit breaker should be installed depending on the mounting site of the
unit. Without a circuit breaker, the danger of electric shock exists.
Do not install near location where there is flammable gas. The unit may
catch fire if flammable gas leaks around it.
Avoid an extended period of direct air flow. It could lead to health problems.
Do not modify the length of the power cord or use an extension cord. It
could cause electrical shock or fire.
Do not attempt to operate the unit with wet hands, this could cause fatal
accident.
Do not turn on the unit by inserting the power cord.
Do not switch off the unit by pulling out the power cord.
Please switch off the unit and turn off the circuit breaker during cleaning, the
high speed fan inside the unit may cause danger.
Turn off the circuit breaker if the unit is not operated for a long period.
Do not splash or direct water to the body of the unit when cleaning it as this
may cause short circuit.
Do not block the air intake and outlet vanes, cooling performance will be
affected.
Ventilate the room occasionally where the unit is installed. Since windows
are kept closed,it does good to open them periodically to ventilate the room.
WARNING
CAUTION
W
A
R
N
I
N
G
PRECAUTIONS DURING INSTALLATION
PRECAUTIONS DURING OPERATION
3

4
Air inlet louver
4-Way airflow direction
Power cord
Control panel
Front grille
Air filter
Outer wrapper
(behind the front grille)
MAIN UNIT: STANDARD
( Cooling Only 7,000;9,000;12,000 BTUH )
TURBO
COOL
HIGH
COOL
LOW
COOL
OFF
FAN
COOLER
WARMER
Air Swing Switch
Thermostat Control
Selector Control
CONTROL PANEL
Automatically controls the room temperature when set to desired temperature.
Turn the knob clockwise for cooler temperature and counterclockwise for
warmer temperature settings.
OFF - completely stops fan and cooling operation.
FAN - provides air at moderate velocity without cooling operation.
QUIET COOL -provides cooling at minimum air velocity, maximum
dehumidification and lowest sound level. This setting is
recommended for night time use.
HIGH COOL - provides cooling at moderate air velocity. This is preferred
when mid-morning and early evening outdoor temperatures
are likely to be lower.
TURBO COOL - provides cooling at maximum air velocity. This setting is ideal
for quick lowering room temperature, but it is not normally
required once the room is cooled.
Activates the vertical louver to automatically
distribute air from side to side for uniform cooling
ON - Air Swing is in operation.
OFF - stops the operation of Air Swing.
OFF
ON
THERMOSTAT
SELECTOR
TURBO
COOL
HIGH
COOL
LOW
COOL
OFF
FAN
COOLER
WARMER
OFF
ON

Air Swing Switch
Thermostat Control
Selector Control
CONTROL PANEL
Automatically controls the room temperature when set to desired temperature.
Turn the knob clockwise for cooler temperature and counterclockwise for
warmer temperature settings.
OFF - completely stops fan and cooling operation.
FAN - provides air at moderate velocity without cooling operation.
QUIET COOL -provides cooling at minimum air velocity, maximum
dehumidification and lowest sound level. This setting is
recommended for night time use.
HIGH COOL - provides cooling at moderate air velocity. This is preferred
when mid-morning and early evening outdoor temperatures
are likely to be lower.
TURBO COOL - provides cooling at maximum air velocity. This setting is ideal
for quick lowering room temperature, but it is not normally
required once the room is cooled.
Activates the vertical louver to automatically
distribute air from side to side for uniform cooling
ON - Air Swing is in operation.
OFF - stops the operation of Air Swing.
OFF ON
THERMOSTAT
SELECTOR
TURBO
COOL
HIGH
COOL
LOW
COOL
OFF
FAN
COOLER
WARMER
OFF ON
MAIN UNIT: STANDARD
( Cooling Only 15,000;22,000 BTUH )
COOLER
WARMER
TURBO
COOL
HIGH
COOL
LOW
COOL
OFF
FAN
Outer wrapper
Front grille
Air filter
(behind the front grille) 4-Way airflow direction
Air inlet louver
O
TURB
OC O L
HG
H
I
COL
O
WL O
COL
O
FOF
FAN
OOL R
C E
EA R R
WM
Control panel
Power cord
5

Air inlet louver
4-Way airflow direction
Power cord
Control panel
Control cover
Front grille
Remote Control
Air filter
Outer wrapper
(behind the front grille)
1
2
3
4
13
4
2
CONTROL PANEL
POWER BUTTON
If you press this button, the unit will begin operation. Press the button again, and
operation stops. (You can hear a receiving beep.)
TEMPERATURE SETTING BUTTONS
If you set the desired room temperature, then the unit will maintain the room
temperature at the set temperature.
TIMER LIGHT INDICATOR
Indicates that the timer function is on used.
OPERATION MODE SELECTING BUTTON
Press this button to select the desired mode.
In COOL mode, the unit will run at the normal cooling mode.
In FAN mode, only fan will operate at the selected fan speed and circulate the
room air.
In DRY mode, fan speed goes to low from auto and dehumidification takes
place.
In AUTO mode, fan speed will be automatically controlled by the
microcomputer of the unit.
MODE
MODE
MAIN UNIT: REMOTE
( Cooling Only 7,000;9,000;12,000;15,000;18,000;22,000 BTUH )
6

Auto
Sleep
Temp
Turbo
Cool
Timer
Fan
Fan
Speed
Dry
Sweep
POWER
+
_
CarrierCarrier
1
8
2
3
4
10
11
7
9
5
6
POWER BUTTON
If you press this button, the unit will begin
operation. Press the button again, and
operation stops.
FAN SPEED BUTTON
Press the button to select the desired fan
speed of LOW,MED, or HIGH.
TEMPERATURE SETTING BUTTONS
If you set the desired room temperature, then
the unit will maintain the room temperature at
the set temperature.
TURBO BUTTON
Press the button to cool quickly the room at
selected temperature.
TIMER BUTTON
Timer can be set on or off. User can set any
time between 1 to 12 hours, by using the (+)
and (-) buttons.
SLEEP BUTTON
Press this button to set the SLEEP timer.
SWEEP BUTTON
Controls the discharge air flow direction left
and right automatically.
COOL BUTTON
In COOL mode, the unit will run at the normal
cooling mode.
FAN BUTTON
In FAN mode, only the fan will operate
AUTO BUTTON
InAUTOmode, the fan speed will be controlled
by the microcomputer of the unit.
DRY BUTTON
In DRY mode, fan speed goes to low from auto
and dehumidification takes place.
17
8
9
10
11
2
3
4
5
6
REMOTE HANDSET
( Cooling Only )
7

8
Front grille
Air filter
Outer wrapper
(behind the front grille)
Air inlet louver
4-Way airflow direction
Power cord
Control panel
Control cover
MODE
MAIN UNIT: STANDARD
( Cooling and Heating 9,000; 12,000; 15,000; 18,000 BTUH )
THERMOSTAT
SELECTOR
AIR
SWING
FAN
FAN
FAN
FAN
OFF
OFF
LOW
COOL
LOW
COOL
HIGH
COOL
HIGH
COOL
LOW
HEAT
LOW
HEAT
HIGH
HEAT
HIGH
HEAT
COOLER
COOLER
WARMER
WARMER
2
2
3
3
1
1
COOLING
COOLING
HEATING
HEATING
1
2
3
Air Swing Switch
Thermostat Control
Selector Control
7
7
8
8
9
9
2
2
6
6
5
5
4
4
3
3
1
1
CONTROL PANEL
THERMOSTAT
SELECTOR
AIR
SWING off on

1
2
3
4
13
4
2
CONTROL PANEL
POWER BUTTON
If you press this button, the unit will begin operation. Press the button again, and
operation stops. (You can hear a receiving beep.)
TEMPERATURE SETTING BUTTONS
If you set the desired room temperature, then the unit will maintain the room
temperature at the set temperature.
TIMER LIGHT INDICATOR
Indicates that the timer function is on used.
OPERATION MODE SELECTING BUTTON
Press this button to select the desired mode.
In COOL mode, the unit will run at the normal cooling mode.
In HEAT mode, the unit will run at the normal heating mode.
In FAN mode, only fan will operate at the selected fan speed and circulate the
room air.
In DRY mode, fan speed goes to low from auto and dehumidification takes
place.
In AUTO mode, fan speed will be automatically controlled by the
microcomputer of the unit.
MODE
MAIN UNIT: REMOTE
9
Air inlet louver
4-Way airflow direction
Power cord
Control panel
Control cover
Front grille
Remote Control
Air filter
Outer wrapper
(behind the front grille)
MODE
( Cooling and Heating 9,000; 12,000; 15,000; 18,000 BTUH )