Carson MicroFlip MP-250 User manual

MicroFlip
™
100x–250x Zoom Pocket
Microscope
i  e
Adapter clip
Eyepiece
LED switch
Focusing ring
UV light
ownward
Facing LED
Front Facing LED
Objective lens
UV light switch
Zooming dial
Battery door
Base plate
Install thebattery
 Slide open the battery door (Fig.1).
 Install 1 (one) AA alkaline battery with thecorrect polarity (Fig.2).
 Attach the battery door (Fig.3).
Fig.1 Fig.2 Fig.3
2

Using the microscope to view objects directly
 ae sre the base plate sits behind the batter door in the pright position (Fig.).
 Press the LED switch to turn on the LED (Fig.). lease note that when base plate is in pright position
onl front facing E will illminate.
 Place the viewing object directly below the objective lens (Fig.6).
Fig.4 Fig.5 Fig.6
Using the microscope to view specimen slides
1. Flip the base plate down so that it sits on the base of the microscope (Fig.).
2. ress the E switch to trn on the E (Fig.). lease note that when base plate is down onl downward
facing E will illminate.
. nsert the specimen slide into the slot between the obective lens and the base plate (Fig.).
Fig.Fig.Fig.
Adjusting zoom & focus
 Adjust the zooming dial tothe desired level
of magnification (Fig.10).
 Rotate the focusing ring until the image is
sharp andclear (Fig.11).
UV light
1. Press and hold the UV light switch to activate the
UV light (Fig.12).
NOTE: The UV light is deactivated when the base
plate is flipped down to the base of the microscope.
Fig.10 Fig.11 Fig.12
WARNING:
Do not look directly
at the UV light.

Using the adaptor clip
Fig.13
lign the camera of the
phone to the center of the
circlar hole of the adapter
clip (Fig.1).
Fig.14
Attach the adapter clip to
the top of the microscope
as shown in Fig. 1 and
trn on camera. Refer to
page 2for procedures of
using the microscope.
f viewing image is not
centered or is not a
complete rond image
adst adapter clip maing
sre it is centered over
camera.
ig
To maimie or image
pinch screen to enlarge.
For best reslts se in
video mode.
WARNING:
Always hold the phone securely during use. If you release
the phone while it is attached to the microscope, it can fall
which may result in damage to the phone.
  

f there is more than one rearfacing camera se the primar one. Tpicall the primar is a 1 wide
angle color camera and the other camera(s) are secondar.

For pple dal camera phones the primar camera is the one closest to the corner. Use photo or video
mode onl.

For ndroid the primar camera can be determined b which does not show an image in or app
while blocing the individal camera.

For the latest instrctions on mltiple camera phones please visit www.carson.coultica.
e  e
• Turn off the LED at the end of the observation by pressing the LED switch.
• Remove the battery before storing the microscope for an extended period.
• To avoid possible permanent eye damage, do not look at the sun or bright objects with the microscope, nor
place the lighted microscope directly upon human eye.
• The device may get warm after extended period of use. This is normal and should notbeconsidered asa defect.
• Inspect all batteries for signs of corrosion or leakage. Do not expose to fire or excessive heat. Use alkaline
batteries only, rechargeable batteries are not recommended.
If you experience any difficulties, please contact us and we will be happy to help you.
In the U.S.A. In the U.K. In the E.U.
Phone: 1-1-96- Phone: [phone] Phone: [phone]
Email: [e-mail] Email: uksuppor[email protected] Email: eusuppor[email protected]
For warranty information, visit www.carson.com/warranty MP-250 / © 201