Carus CAI 1100 User manual

Assembly instruction
- CAI 1100 -
Attention
The indoor stations have to be (de-)installed only voltage-free!
When installing the adaptor plate on uneven surfaces it has to be ensured that the screws are not overtightened. Overtighten the screws
may lead to a deformation of the adaptor plate. As a result contact problems might occur. Further, the correct snapping-on of the device
on the adaptor plate might not be possible.
Install the adaptor plate
For an optimal operation, a mounting height of 1.60m is recommen-
ded (upper edge of the device). In order to place the cables without
any problems, a fl ush-mounted socket must be installed behind the
device.
Position the fl ush-mounted socket behind the adaptor plate so that all
drill holes can be used to fi x the plate to the wall and that the
connection terminal does not contact the fl ush-mounted socket. Plea-
se use the adaptor plate only as a support tool for marking
the holes. Do not use the adaptor plate as drilling template! Install the
adaptor plate with the 4 enclosed screws to the wall.
Connect the lines
Connect the lines according to the labeling.
a
b
E
P

www.carus-concepts.com
- Art. no. 0035875 Version 1 A -
Install the device
Take the device into both hands and centre it on the
middle of the adaptor plate. There must be around
10mm space to the lower edge of the adaptor plate.
Slightly press the device fl ush to the adaptor plate (1)
and move it carefully downwards (2) until the holes in
the backside of the device look into the locking bolts.
Push it downwards now until the stop. To control if
the device is snapped-on correctly, slightly try to push
it upwards. This should not be possible.
Deinstall the device
For the deinstallation of the device the enclosed
release bracket is needed. Insert the release bracket
behind the device into the opening in the adaptor
plate (1). Push the device upwards (2) and pull it off
forward (3).
(1)
(2)
(3)
(1)
(2)
Locking bolts (4x)