Carus CAI 1010 User manual

ET
87546321S
a
b
P
Assembly instruction
CAI 1010
Attention
The indoor stations have to be (de-)installed only voltage-free!
The table rack is pre-confi gured and has to be connected to a RJ45 socket. Therefore, please note the connection diagram under “cable
assignment“!
Cable assignment Cable is already pre-installed.
wires connect to
plug PIN no. connection terminal
2 orange a
3 green/white b
4 blue E
5 blue/white P
(1) adapter plate
(2) lock pins (4x)
(3) connecting cable (2.5 m)
(4) knurled screws
(5) grub screw / hexagonal socket
(2)
(4)
(3)
(1)
(5)
Set up the table rack
Turn the table rack into the desired position and fi x the position by tightening the knurled screws by hand.
Connection terminal UAE socket with 8 pins
max. 60°

www.carus-concepts.com
- Art. no. 0035874 Version 1 A -
Install the device
Take the device into both hands and centre it on the middle of the adapter plate. Leave around 10mm space to the lower edge of the
adapter plate. Slightly press the device fl ush onto the adapter plate (1) and move it carefully downwards (2) until the holes in the backside
of the device look into the lock pins. Push it downwards now until the stop.
Tighten the grub screw with a suitable screwdriver only by hand!
To make sure that the device is snapped-on correctly, slightly try to push it upwards. This should not be possible.
Deinstall the device
Loosen the grub screw for deinstalling the device. Take the device into both hands. Push the device upwards (3) and pull it off towards
you (4).
(3)
(4)
(1)
(2)
lock pins (4x)
grub screw