Carus CAI 2010 User manual

ET
546321S
a
b
P
V1
V2
M
Assembly instruction
CAI 2010
Attention
The indoor stations have to be (de-)installed only
voltage-free!
The table rack is pre-confi gured and has to be con-
nected to a RJ45 socket. Therefore, please note the
connection diagram under “cable assignment“! In
delivery state the device is equipped with a termina-
ting resistor. Observe the notes for installation under
“terminating resistor“ when installing a video device.
Set up the table rack
Turn the table rack into the desired position and fi x
the position by tightening the knurled screws by
hand.
max. 60°
Connection terminal UAE socket with 8 pins
(1) bottom shell
(2) screws (4x)
(3) connecting cable
(2.5 m)
(1)
(2)
(3)

www.carus-concepts.com
- Art. no. 0035880 Version 1 A -
Deinstall the device
There is a rectangular release opening at the undersi-
de of the device (3). Insert a small screwdriver straight
and with slight pressure into this opening. The screw-
driver must not be wider than 7mm and thicker than
2 mm, otherwise the top shell can get damaged.
The top shell can be removed at the underside
now (2). Lift the top shell out of the two upper
adjustment brackets (1).
(1)
(2)
Install the device
Position the top shell at both adjustment brackets of
the adapter plate (1). Snap-on the top shell below
with slight pressure (2).
Terminating resistor
The monitor of the tabletop device is equipped with
a terminating resistor ex works. The installation of
the lines to the connection socket must be reali-
sed star-shaped and must NOT be looped through.
Noncompliance leads to a video image with limited
quality.
(3)
Cable assignment
The cable is already pre-installed.
wires connect to
plug PIN no. connection terminal
2 orange a
3 green/white b
4 blue E
5 blue/white P
6 green M
7 brown/white V1
8 brown V2
(3)