SHENZHENGUIYUANINDUSTRYDEVELOPMENTCO.,LTD
Wireless Remote ControlVibrator/ Beeper
PackageInclude:
•4xReceiver: Z-06 (Vibration &Beep mode)
•1xTransmitter: CB-4L
•1xUser manual
Feature:
•Wireless control.
•You can controlthereceiver withtransmitter (remotecontrol)fromanyplacewithinareliabledistance,the wirelesssignalcan pass
through walls, floorsand doors.
•Reliablecontrol: The transmitter (Encoding) and the receiver (Decoding) usean8-bitcode.
•One/severaltransmitterscan controlone/severalreceiverssimultaneously.
•If you usetwoor more receiversinthe sameplace, you can setthemwithdifferentcodes.
•Transmitting Frequency: 433MHz
Receiver:
•ModelNo.: Z-06
•3Modes: Vibration,Beep,Vibrationand Beep
•Decode: Learning code
•Power Supply: 2xAAA1.5VBattery(included)
•Size: 77mm x38mm x17mm
•
Transmitter:
•ModelNo.: CB-4L
•Channel: 4CH
•RemoteControlDistance: 1000m/3000ft (theoretically)
•Encode:EV1527Learning code (upto1million codes, reducing code collisionand unauthorized code scanningpossibilities.)
•Unitsize: 135mm x42mm x25mm
•Power Supply: 1x6F22-9V battery(included,canbe usedfor 12months)
Usage:
•Vibrationmode:Pressthebuttonof transmitter,the receiver vibratesfor 5seconds.
•Beep mode:Press thebutton oftransmitter,the receiver beepsfor 5seconds.
•Vibration&Beep mode:Press the button of transmitter,thereceiver vibrates and beepstogether for5seconds.
•Changing modes: Aslongaspressthe buttonofreceiver,youcanswitchthosethree working modesoptionally.Suchaspressthe
button ofreceiver,switchtobeep modefromvibrationmode;pressthe button oftransmitter again,switchtovibration&beep mode;
press the button oftransmitter again,switchtovibrationmode.
•Eachbuttonoftransmitter can controlone receiver.
•Wehavelearnedremotecontroltothereceiver.If you don twantthe receiver towork withthe remotecontrol,you can deleteallstored
codes:
Deleteallstoredcodes:Press and holdthebutton of thereceiverforabout5seconds untilLEDlight turnsonandgo onholdingtillLED
lightturnsoff, then releasethe button,all stored codeshavebeen deleted successfully. Atthistime, thetransmitter cannot controlthe
receiver.
•Learning remotecontrols:
1) Press and holdthelearning button ofthereceiver for about5seconds,then releasethe buttonwhenLEDlightison, the receiver is
inthe statusofLearning.
2) Press button of remotecontrolwithin10 seconds,if LEDlightflashes twicethen off, itmeansLearning issuccessful.
If LEDlightisoff after 10 seconds, it means Learning isfailed andthereceiver quitsthe statusofLearning.
3) The receiver can learn severalremotecontrols of different codes.
Note:
Ifyou wanttodelete allstoredcodes,you shouldfirstswitchoff thereceiverand switchonagain,thenyou cangoon
deletingcodes.
