Case Cross User manual

Cross
Round Coffee Table
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com
Cross Round Coffee Table – designed by Matthew Hilton
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured with either oak or walnut.
Craftsmen manufacture this product and there is variety between each unit. This is
because wood is a natural product, with natural colour and grain variations.
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

Assembly Instructions
Required
A x 8
B x 4
C x 4
D x 4
E x 4 A
D
A
E
FF
B
C
F x 1
Step 1. Assemble the leg section together by
screwing in tting D into both sides of the
centre leg making sure the hole through the
centre of the tting D is facing towards the top.
place in the dowels (tting A) and take one of the
1/2 leg sections, insert tting E into the top and
bottom of the leg ensuring the clearance holes
are aligned. Attach the legs and tighten tting E,
repeat for the remaining leg.
Step 2. Place the four remaining dowels (tting A)
into the holes in the underside of the table top
as shown above. With help carefully place the leg
section onto the table top aligning with the dowels.
Insert tting B and C into the relevant holes and
fully tighten.
With help carefully turn the table over.