4] ASSEMBLY
4cdvigroup.com 5cdvigroup.com
Position the box-section backplate,
complete with
pre-tted electro-magnetic locks, on to the door
frame - ensure the positioning will allow for the
architectural handle to close securely over the
section. Once you are satised with the position,
mark the vertical and horizontal holes, then drill as
required. Take note of the cable entry holes, and
feed the cables through. Fix the section into place,
then wire the electromagnetic locks in accordance
with the wiring schematic in Section 5. Fit the box
section cover into place, x the end caps and secure
with the screws provided. To nalise the assembly,
tighten all xings, and protect the handle xing
section by tting the cover and end caps.
With the door closed, position the architectural
handle onto the edge of the opening leaf of the door,
ensuring the handle covers the box-section. Mark
the vertical and horizontal holes, drill as required,
then temporarily x the handle leaving a small gap
around the box section – check the alignment of the
magnets in the box section with the armatures in
the handle. Adjust if necessary, then once satised,
secure the handle by completing the xings.
Insert the end caps and secure.
ENEN BO600RH
Horizontal retrot housing
BO600RH
Horizontal retrot housing
INSTALLATION MANUALINSTALLATION MANUAL
Position the box-section backplate,
complete with pre-tted electro-
magnetic locks, on to the door
frame (or xed door leaf if
installing onto double doors) -
ensure the positioning will allow
for the architectural handle to
close securely over the section.
Once you are satised with the
position, mark the vertical and
horizontal holes, then drill as
required. Take note of the cable
entry holes, and feed the cables
through. Fix the section into place,
then wire the electromagnetic
locks in accordance with the
wiring schematic in Section 5. Fit
the box section cover into place,
t the end caps and secure with
the screws provided. To nalise
the assembly, tighten all xings,
and protect the handle xing
section by tting the cover and
end caps.
1
Cut the top cover unit into 2
pieces. Double check the length of
each section of top cover before
nal cutting. Take into account
the plastic handle (215MM).
Ensure the plastic handle is at
optimum position for users, then
make the nal cuts to the covers.
Insert the end caps and secure.
Insert the plastic handle and clip
it into position. Secure the handle
with the 2 screws.
3
With the door closed, position the
architectural handle onto the edge
of the opening leaf of the door,
ensuring the handle covers the
box-section. Mark the vertical and
horizontal holes, drill as required,
then temporarily x the handle
leaving a small gap around the
box section – check the alignment
of the magnets in the box section
with the armatures in the handle.
Adjust if necessary, then once
satised, secure the handle by
completing the xings.
2
BO600RH
BO600RP
