Channel Vision Aria IC812 User manual

Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
p
roduct with new or rebuilt parts, free of charge in the USA, for ten
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
p
roof of original purchase date will be required before warranty
repairs are provided.
Mail in service can be obtained during the warranty period by calling
[phone] toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
500-184 revA1
10
IC812
8” IN-CEILING SPEAKER
By
7

2
Model IC812
Installation:
h
h
h
h
h
h
Use the provided template to mark and cut a ” hole in
drywall away from ceiling joists.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, both speakers must be wired alike.
Connect red wires to red terminals on the speakers and
to red or plus terminals on the amplifier.
Aim tweeter
To control the volume of the speaker locally, use an
impedance matching volume control, such as the
Channel Vision VC300.
9-½
Install IC812 in the hole. Tighten the mounting screws.
The mounting “dogs ears” will rotate outward and grip the
drywall. the screws. A battery
operated drill on a “low clutch” setting is recommended.
DO NOT OVER TIGHTEN
Mounting screws (4)
3
Features:
8” High performance in-ceiling loudspeaker
High power handling capacity
Gold speaker terminals
Proprietary pivoting “Pole Piece” technology with 1” voice
coil.
Polypropylene woofer with butyl rubber surround and an 18
ounce magnet
Small perforated designer grille
Recommended power: 20W to 180W (peak)
Specifications:
Frequency range:
Crossover:
Sensitivity:
Power Handling:
Drivers:
Magnet:
Impedance:
Finish:
Dimensions:
35Hz - 20kHz ± 6dB
12dB/octive (low pass)
12dB/octive (high pass)
91dB (1W/1m)
180 Watts peak
1- 1” Soft dome tweeter
1- 8” polypropylene woofer
24-ounce ferrite magnet
8 ohms
ABS plastic
10 OD. 4-½ height
(from surface of wall board)
hole size: 9 diameter
-¾” ”
-½”
Specifications subject to change without notice.