Channel Vision Aria IW601 User manual

Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
p
roduct with new or rebuilt parts, free of charge in the USA, for ten
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
p
roof of original purchase date will be required before warranty
repairs are provided.
Mail in service can be obtained during the warranty period by calling
[phone] toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
500-20
3
rev A1
10
www.channelvision.com
234 Fischer Avenue, Costa Mesa, California 92626 USA
[phone] [phone] [phone] fax
email: [email protected]
IW601
6.5” IN-Wall SPEAKER
8

2
Model IW601
Installation:
h
h
h
h
h
Use the included template to mark and cut a hole in the
drywall.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, all speakers in the system must be
wired alike. Connect red wires to red terminals on
speaker and to red or plus terminals on amplifier.
Install the IW601 in the hole. Tighten the mounting
screws. The mounting dog ears will rotate outward and
grip the drywall.
Aim tweeter
Mounting screws (6)
3
Specifications:
Frequency range:
Sensitivity:
Power Handling:
Drivers:
Impedance:
Finish:
Dimensions:
Hole Size:
45Hz - 20kHz ± 3dB
90dB (1W/1m)
150-Watts Peak
1- 1” soft dome tweeter
1- 6.5” polypropylene woofer
8 ohms
ABS plastic
12.0”H x 8.75”W x 3.44”D*
*from surface of wall board
10.625”H x 7.25”W
Specifications subject to change without notice.
Features:
High power handling capacity
2nd order crossover 12dB per octave with poly switch for
tweeter protection.
6.5” polypropylene woofer with butyl rubber surround
1” pivoting soft dome tweeter
Gold speaker terminals
Small perforated designer grille
Mounting template and paint shield included (rough-in
bracket sold separately model: IW65B)
Recommended power: 20W to 100W