Charge Amps Ray User manual

CHARGE AMPS RAY
User manual

© 2021 Charge Amps AB
Us
er manual for Ray
Doc. Nr: 13
0167
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
2
Table of Contents
Safety precautions ........................................................................................ 3
Warning ............................................................................................................. 3
Caution .............................................................................................................. 3
Charging current ............................................................................................... 4
To start charging ........................................................................................... 5
To stop charging ........................................................................................... 5
Disposal ............................................................................................................. 5
Rights ............................................................................................................. 6

© 2021 Charge Amps AB
Us
er manual for Ray
Doc. Nr: 13
0167
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
3
Safety precautions
Read safety precautions below before use.
Warning
Due to mishandling a dangerous condition might occur such as electric shock of fire.
•Before you connect the Ray make sure the correct charging current is selected.
You must ensure that the outlet and circuit have enough current capacity to
charge your vehicle safely. The outlet and circuit must be earthed and protected
by a dedicated circuit breaker (max 16 A) or fuse (max 16 A). If in any doubt,
consult a qualified electrician. Overloading an outlet may result in fire.
•Do not use an extension cord or adapter.
•Always connect the Ray to an RCD protected outlet. The Ray is equipped with an
RCD to protect the cable, connector, and car from ground faults, but always use
an RCD protected outlet for your personal safety.
•Do not disassemble or try to repair. Contact vendor if service is required.
•Stop using the Ray if a failure or abnormality occurs or the cable is damaged.
•Stop using the Ray if the display shows any faults.
•Stop using the Ray if it gets very hot. The Ray will get warm during charging, this
is normal.
•Keep the plug dry and take appropriate care when operating in wet conditions.
•Do not touch the electric terminals of the Ray.
•Do not use the Ray if any parts are broken, worn, cracked, and open or show any
indication of damage. Contact vendor if you are uncertain if it is safe to use your
Ray.
•Not for use by children.
•Ensure the electrical supply is 220–240 V 50/60 Hz.
•Handle the Ray with care; do not drop and do not pull the cable firmly.
•Ensure that the Ray is placed to avoid immersion in water.
•Do not hang the Ray in the cable.
Caution
Parts could be damaged due to mishandling.
•Prevent foreign matter from getting into the terminal parts of the Ray.
•Avoid stepping on, place heavy objects on, or driving over the Ray
•Avoid making tight loops, folding or twisting the cable.
•Avoid using the Ray during electrical storms or thunderstorms.
•When charging, make sure the Ray is not covered by objects preventing cooling
of the Ray.

© 2021 Charge Amps AB
Us
er manual for Ray
Doc. Nr: 13
0167
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
4
•Do not drop the Ray.
WARNING – This manual contains important instructions for the Ray electric
vehicle charger that must be followed during operation, and maintenance of
the unit. When using electric products, basic precautions should always be
followed, including the following instructions.
CAUTION – Instructions pertaining to a risk of fire or electric shock. Save
these important safety instructions.
WARNING – Do not use Ray for any other purpose than to charge an
electric vehicle.
Charging current
You should always have good knowledge about the electrical installation before you start
charging and make sure the installation handles the load correctly. Charging with high
current requires that the outlet is rated for the load continuously and that the cable
dimensions between the electric central and the outlet are of adequate size. You should
also make sure that the installation and outlet are in good shape and can handle the
continuous load.
If you are uncertain about the quality or capacity of the electrical installation consult your
certified electrician.
See safety precautions for more information.

© 2021 Charge Amps AB
Us
er manual for Ray
Doc. Nr: 13
0167
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
5
To start charging
1. Connect Ray to an outlet socket. Make sure to always do this step first.
2. Ray will start and indicate the selected charging current on the display.
3. Make sure Ray cable is not creating a coil
4. Selected the desired charging current by maneuvering the touch sensors. Press
settings (gear-wheel) and the adjust current with the up/down arrows on the
screen and end with OK (green check).
5. Insert the Ray into the EV. Charging starts automatically. The display will begin to
show a charging graphic.
To stop charging
To prevent arching and wear on plugs and outlet, the order of removal is important. The
following procedure minimizes the risk of arching.
1. Unlock your car.
2. Remove Ray from your car.
3. Remove the socket plug from the outlet
Disposal
The Ray contains electronic components and should be recycled as such. Contact your
local recycling center for information about recycling and where to dispose of your
electronic products.
You can also send items back to Charge Amps for proper disposal. Contact info@charge-
amps.com for instructions.

© 2021 Charge Amps AB
Us
er manual for Ray
Doc. Nr: 13
0167
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE
-169 75 Solna
Sweden
Contact:
[phone]
info@charge
-amps.com
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
6
Rights
The information in this document has been checked for accuracy. Charge Amps AB
reserves the right to make technical changes and changes to the contents of the
document without prior notice. Charge Amps AB can therefore not guarantee that all of
the contents of this particular document are accurate, up-to-date, and free from printing
and proofreading errors. Moreover, Charge Amps AB cannot be held liable for any
mistakes, near-misses, injuries/damage or incidents – direct or indirect – that can be
linked to the use of the regulations or products in this document.
Charge Amps AB reserves all rights to this document, as well as the information and
illustrations therein. It is strictly forbidden to – in whole or in part – copy, adapt or
translate the information without prior written permission from Charge Amps AB.
© Copyright 2021 Charge Amps AB. All rights reserved.