Chiayo SQ-6100 IrDA User manual

CHIAYO ELECTRONICS CO.,LTD.
Operation manual
069 9
IR RF AF SYNCCHANNEL 1
MIN MAX MIN MAXIR RF AF SYNCCHANNEL 2
NDR-3120
DIVERSITY RECEIVER
SQ-6100 IrDA
UHF Handheld Microphone

1
SQ-6100 IrDA UHF Handheld Microphone
Parts and functions
Cartridge
Battery power LED
Power switch
LCD
Setting button
Menu button
IrDA synchronizing button
B
attery compartment
Color cap
Charging port

2
Instructions
Battery installation & indicator
●►○
●
When the transmitter is switched
ON, a blue LED will blink once to
denote the batteries installed are
in good condition.
If the LED remains illuminated, it
means the batteries are weak and
require replacement.
This transmitter requires 2 x AA
batteries to operate.
To install, remove the battery cover
and slide the batteries into the
battery compartment & replace the
battery cover.
Note: Batteries contain a corrosive acid that may leak and damage the
transmitter when stored for a long period. Batteries should be removed
from the transmitter before storing without use for more than 4 weeks.

3
SQ-6100 IrDA UHF Handheld Microphone
Channel setting
1 Use MENU button to go to the CHANNEL｜FREQUENCY
page.
2 Press and hold the SET button for 3 seconds, then the upper-
right channel number will flash to allow changes to be made.
3 Press SET / MENU buttons to change the channel number. The
corresponding frequency will change accordingly.
4 3 seconds after selecting a channel, it will be automatically
saved.

4
Instructions
Channel synchronizing of the receiver and transmitter
Align infrared areas of the receiver and transmitter within 10~30cm.
Changing the receiver’s channel
Press the synchronizing
button of the transmitter.
The transmitter's LED will
grow to denote transmitting the
frequency to the receiver and
synchronizing the channels.
Changing the transmitter’s
channel Press the
synchronizing button of the
receiver and the receiver will
transmit the frequency to the
transmitter and synchronize the
channels The transmitter's LED
will grow to denote its channel
synchronized by the receiver.
If it doesn’t work check that you have the IR sensor panels aligned, that
they are facing each other, devices are within 10~30cm of each other, and
try again.
FREQSQ
RF
630000
VOL
SET
30cm
CH
FREQSQ
RF AF
AB
001
630000
VOL
CH
FREQSQ
RF AF
AB
0 0 1
630000
VOL
SDR-6120
Wireless Receiver SET SYNCSET SYNC
STEP 2
STEP 1
STEP 2
STEP 1
10~30cm

5
SQ-6100 IrDA UHF Handheld Microphone
Battery type setting
1 Use MENU button to go to the BATTERY TYPE page.
2 Press and hold SET button for 3 seconds, then the cursorwill
flash to allow changes to be made.
3 Press SET button to select either NiMH (rechargeable battery)
or AKLN (alkaline battery).
4 3 seconds after selecting a battery type, it will be automatically
saved.

6
Instructions

CHIAYO ELECTRONICS CO.,LTD.
Http://www.chiayo.com.tw｜Email: [e-mail]
Office: 30, Lane 27, Section 4, Jen-Ai Road, Taipei 10685, Taiwan
Tel: [phone]｜Fax: [phone]
Factory: 88, Chung-Hsiao Street 2, Chiayi 60080, Taiwan
Tel: [phone]｜Fax: [phone]