CLA-VAL VC-22D User manual

Model VC-22D
Electronic Valve Controller
For full manual, go to:
www.cla-val.com/electronic-products
Click on the following links:
1. Valve Controllers
2. VC-22D
3. Technical Manual
4. VC-22D IOM Manual
Loosen 6 screws
1Swing blue faceplate open
2
4Aach power cables to V+/V- terminals. For input/output wiring, see full manual.
12-24 VDC (V+)
0 VDC (V-)
QuickStart
Swing blue faceplate closed
5
Tighten 6 screws
6
POWER SUPPLY GREATER THAN 32 VDC WILL
DAMAGE DEVICE AND VOID WARRANTY.
USE POWER SUPPLY BETWEEN 12-24 VDC ONLY.
CAUTION
Power On Device
3Run power cable through gland.
All manuals and user guides at all-guides.com

Model VC-22D
Electronic Valve Controller
QuickStart
Load Standard ValvApp
Press le navigaon arrow to load standard ValvApp.
1Highlight North America and press OK buon. 2
Highlight desired ValvApp and press OK buon.
3Say yes to load library, and OK to restart unit. 4
If using standard ValvApp, say yes to wizard.
If using custom ValvApp from USB, say no.
5
Accessing Config Menus
See input valuesLong le
See outputs values
Long Right
Set control parametersLong Up
Set interacve variablesShort Down
“Short” = push and release quickly, “Long” = push and hold for 2 seconds
All manuals and user guides at all-guides.com