Cleveland SteamCraft 24CGP10 User manual

Cleveland
™
Project ________________________________
Item __________________________________
Quantity _______________________________
FCSI Section ____________________________
Approval _______________________________
Date __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: [phone]
Fax: [phone]
Web Site: www.ClevelandRange.com
Email: [e-mail]
STEAMCRA T®GENERATOR STYLE
HIGH SPEED CONVECTION STEAMERS
Stea Craft ®Power 10
TWO COMPARTMENT FLOOR MODEL DESIGN
GAS STEAM GENERATORS
240M BTU,
24" WIDE MODULAR DESIGN
MODEL: 24-CGP-10
Cleveland Standard Features
IIPressureless cooking permits doors to be opened during oper-
ation. Capacity for up to ten 12" x 20" x 21⁄2" deep Cafeteria
pans, five each compartment.
IIExclusive PowerPak Gas Steam Generator:
High Efficiency orced Air (Power Burner) Gas ired Boiler
has 240,000 Btu's Input, produces 180 Ibs of steam per hour.
10-12 PSI operating generator pressure. Steam generator is
equipped with a High-Limit Pressure Safety Switch, 15 psi
Safety Valve and a Secondary Low Water Shut Off Safety
standard. ully insulated rear mounted steam generator. Gas
Pressure Regulator and Control Valve included standard.
IIBoiler Descaling Port Connection: Inlet and Outlet descal-
ing port connections for use with the Descaling Pump
IIInstant Steam Stand By Mode: Holds generator at a
steaming temperature. Allows unit to start steaming instantly.
IIDurable 14 Gauge, Stainless Steel Construction: or
compartment door, cavity and cabinet frame.
IITwo 60 Mechanical Timers with ON/O Main Power
Switch with a Heat On, Low Water Indicator Lights and High
Temperature Safety Light and Shut-off (Reset Light).
IIMain Power On/Off Switch: Controls the electric power and
automatically fills the generator with water. A separate Steam
Switch ignites the burners via a fully automatic Electronic
(pilotless) Spark Ignition.
IIExclusive Steam Cooking Distribution System:
Exclusive Brass Steam Jets produce a high velocity
convection steam without fans. Coved Corner design in
cooking compartment distributes heat evenly, easy to clean.
Creased top & bottom enhance drainage. Cold Water
Condenser for each compartment maintains a dry steam. ully
insulated cooking compartment for thermal efficiency.
Removable Stainless Steel Slide Racks. Reversible Door
Gasket.
IIAutomatic Boiler Drain: Contains a “Water Jet” Spray Rinse
Drain Cleaning Cycle to keep drain clear.
IIExclusive Automatic Float for Water evel Control:
Separate from the generator for easy access, contains a high
velocity rinse cycle to eliminate mineral buildup.
IIExclusive “Cool to the Touch” Two-Piece Compartment
Door Design: ree floating inner door with reversible gasket
provides an air tight seal. Stainless Steel Slam/Latch Door
mechanism for reliability.
IICondensate Drip Trough: Provided under lower
compartment door to collect condensate.
IIeft Hand Door Hinging: Compartment Doors hinged on the
left, controls on the right.
IINSF Certified 6˝ Stainless Steel egs with adjustable
flanged feet for a one inch level adjustment.
IICSD-1 Compliant
Shall be CLEVELAND, SteamCraftPower 10 , two compartments,
Floor Model Steamer, Model 24-CGP-10. Sin le, lar e capacity
Gas-fired Pressure Steam Generator, 240M BTU input. Exclusive
Automatic Water Level Float desi n. Steam Generator with
Automatic Water Fill on start up, Automatic Generator Blowdown,
Electronic Spark I nition and Generator Standby for instant steam.
Choice of Compartment Controls, Manual By Pass Operation
Mode. Exclusive Cold Water Condenser desi n.
Options & Accessories
ËBoiler Descaling Pump Kit (107142)
ËRight hand Door Hinging, Controls on Right (DHR)
ËElectronic Timer with Compensating Load eature (ETC)
ËON/O Steam Switch for compartment controls (MC)
ËPower Take Off Kit (GPTO-1O)
ËKettle Interconnecting Kit (IMK-)
ËCompartment Door Steam Shut Off Switch (SCS)
ËCafeteria Pans in depths of 1", 2
1
⁄ 2 ", 4" and 6"
ËType of gas other than natural
ËDissolve
®
Descale Solution, 6 one gallon container w/quart
markings (106174)
ËWater ilters
ËCorrectional Packages
Short For Specifications
SECT. IV PAGE 19
1007

SCALE .75" = 1'
SECT. IV PAGE 20
1007
itho in U.S.A.
UTI ITY CONNECTIONS
E ECTRIC
115V - 1 Phase
1 an & Controls - 150
Watts
** Do not connect to G I
outlet. See note below.
GAS CO D WATER DRAINAGE
C1 C2
C1
C2
D
35 psi minimum
60 psi maximum
3⁄8˝ Dia. NPT for
Generator
3⁄8˝ Dia. NPT for
Condenser
1
1
⁄ 2 ˝ dia.
Do not connect other units to this drain
Drain must not be located beneath the steamer
itself. Preferred floor drain location should be a
minimum distance (from the unit) of at least 12”
from the left side, 12" from the right side, 6”
from the front and 6" from the rear
Do not use PVC pipe
240,000 BTU - Piping 11⁄4˝ IPS Line Size, 3⁄4˝ Connection
C1 C2
C1
C2
C1 C2
C1
C2
SUPP Y PRESSURE
NATURAL PROPANE
4.00˝ W.C. minimum 12.00˝ W.C. minimum
14.00˝ W.C. maximum 14.00˝ W.C. maximum
Manufacturer must be notified if unit will be used above 2,000
ft. altitude.
10 — 12˝ x 20˝ x 21⁄2˝ Cafeteria Pans or
20 — 12˝ x 20˝ x 1˝ Cafeteria Pans or
26 — 12˝ x 20˝ x 4˝ Cafeteria Pans
TOTA CAPACITY (2 Compartments)
Electrical Supply Drain: 1.50˝ Dia. lue Gas Exhaust from Boiler
Cold Water Supply for Condenser 3/8˝ Dia. NPT Gas Supply .75˝ Dia. lue Diverter
Cold Water Supply for Generator and Water Injection. Power Take Off Connection
3/8˝ Dia. NPT (for water treatment conn.) 3/8˝ Dia. IPS
Unit comes with a 50 Mesh Water Strainer (installation required)
A
B
C
H
G
D
I
Each Compartment has
capacity for:
• ive, 12˝ x 20˝ x 21⁄2˝ deep
Cafeteria Pans.
WATER QUA ITY
REQUIREMENTS
The quality of water varies
greatly from region to region.
Steam equipment generators
must be drained daily and
chemically descaled periodically
to ensure proper operation. To
minimize service problems
caused by the accumulation of
minerals and chemicals in water
review the following quality
guidelines with a local water
treatment specialist. Inlet water
that is beyond these specified
guidelines should be treated to
achieve these acceptable limits.
Total Dissolved Solids less than
60 ppm, Alkalinity less than 20
ppm, Silica less than 13 ppm,
pH factor greater than 7.5,
Chlorine less than 30 ppm.
NOTES:
**DO NOT CONNECT TO G I OUTLET. CLEVELAND RANGE RECOMMENDS GAS IRED 120 VOLT STEAMERS BE HARD WIRED DIRECTLY TO ELECTRICAL SYSTEM.
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are ASME/N. Bd, UL/NS #4 and CSA (AGA, CGA).
C EARANCE
Right - 3”, Left - 3”,
Rear - 3”
(12” on control side if
adjoining wall or equip-
ment is over 30” high
for service access)
Contact factory for
variances to clearances.