Cleveland IWC-PDW User manual

Cleveland
™
Project ________________________________
Item __________________________________
Quantity_______________________________
FCSI Section ____________________________
Approval _______________________________
Date __________________________________
1333 East 179 St.,
Cleveland, Ohio,U.S.A. 44110
Tel: [phone]
Fax: [phone]
Web Site:www.ClevelandRange.com
Email: [e-mail]
OPTIONS & ACCESSORIES
Cleveland Standard Features
nWelded Steel Construction
nFurnished with 8 each 5/8"-11 NC studs for supporting
steamer Carrier Channels. Does not include necessary
Double Hex Nuts (16 each 5/8"-11 NC)
nProvided with eight, floor studs holes (11/16" Diameter)
to receive pre-set floor studs (5/8" diameter)
nTobe imbedded in floor and wall and covered with
appropriate surfaces
nIn-Wall Carrier is required for Wall-Mounted Units and
should be included in specification for Steamer
nCompleted installation provides unobstructed floor area
for cleaning
Options & Accessories
pMounting Studs, in lengths other than standard
Shall be CLEVELAND, Model IWC-PDW, In-Wall Carrier, Steel, for installing
Cleveland Pressure Steamers. Includes (8) Supporting Studs 5/8" - 11 x
2 1 /2" long .
Short Form Specifications
SECT. XIII PAGE 5
0707
IN-WALL CARRIER
FOR USE WITH WALL MOUNTED,
DIRECT STEAM, PRESSURE STEAMERS
MODEL:cIWC-PDW

(NOT TOSCALE)
SECT.XIII PAGE 6
0707
Litho in U.S.A.
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., NSF, CGA, CSA, ETL and others.