Cooper Lighting HALO L1631 User manual

322
TRACK LIGHTING Recessed Raceway
COOPER LIGHTING
HALO®
When Architectural Needs
Require a Minimal Look,
Use Halo Recessed Raceway
Single Circuit Raceway Power-Trac is
designed for installation in plasterboard
ceilings or for use with tile ceilings in
straight runs only. Available in 4’ and 8’
lengths.
Size
Recessed Raceway Trac is 1 11/32” (34mm)
deep with a 3 1/32” (77mm) wide flange
area.
Finish
Available in a white finish.
Connectors
The system uses two connectors, a L1931P
Live End Connector to start a run and a
L1933P Straight Connector when con-
necting two sections of straight track end
to end.
Grounding
To ensure safe operation the entire track
system is fully polarized and grounded.
Grounding is accomplished automatically
by a separate solid copper ground
conductor in the track. The ground
conductor maintains continuity to the
building’s grounding system through the
ground contact fingers in each of the
connectors.
Specifications
The structural channel is extruded
aluminum with .070” nominal wall
thickness. Conductors are solid copper
buss bars encased in rigid extruded
polyvinyl insulators. Connectors are
molded of polycarbonate. Recessed
Raceway Trac is UL listed, CSA certified.
Raceway
Top portion of track is designed as a
raceway. Will carry up to 6 #12 AWG
conductors. Can be used to feed addition-
al sections of track from the original feed
point, minimizing installation time and
cost. Raceway covers are included.
Recessed Raceway Trac will accommodate
the following accessories: L932 Cross
Tee Adapter Clip, L934 Cross Tee Adapter
Clip, L935 Recessed Housing Hanger, L938
Cross Tee End and L939 Lathing Tab.
L1631, L1632
•L1631-4’–Recessed Raceway Trac
Actual length: 44 1/8” (1120mm)
Finish: White (P)
•L1632-8’–Recessed Raceway Trac
Actual length: 92 1/8” (2340mm)
Finish: White (P)
ACCESSORIES
L1931 Live End Connector
To start a run.
Finish: White (P)
L932 Cross Tee Adapter Clip
Use in track housing groove to assemble 15/16”
cross tee. For use with Chicago Metallic 200
System, National Rolling Mills ML System, Donn
Corporation DX System.
L934 Cross Tee Adapter Clip
Use in track housing groove to assemble 9/16”
cross tee. For use with Chicago Metallic Tempra
4000 System, National Rolling Mills SLK System,
Donn Corporation Centricitee System.
L1933 Straight Connector
Connects two sections of straight trac end-
to-end.
White (P)
L935 Recessed Housing Hanger
Use to suspend Recessed Power-Trac
Housing.
L938 Cross Tee End
For use when cross tee is cut. Pop rivet to
cross tee and insert into L932, L934 cross tee
adapter.
L939 Lathing Tab
Use to suspend Recessed Power-Trac
Housing to carrying channel (10” long).