Costway TQ10020 User manual

USER'S MANUAL
Children Motorcycle
TQ10020

Always
02

Please see Battery Charging part for
Warning. Should wear protective equipment. Not to
be used in traffic.
detailed instructions.
drive.
A
A
O
03

prior
cracks or breaks exist
worn
04

Alterations could cause a fire, resulting in
serious injuries.
Your 6 volt battery is equipped with a built-in
thermal fuse. The thermal fuse is a self-resetting
safety device which automatically trips and shuts
down operation of the vehicle if the vehicle is
overloaded or the driving conditions are too severe.
Once a fuse has tripped, it will automatically reset
itself after approximately 10 seconds and allow the
vehicle to resume normal operations. To avoid
repeated automatic shut downs, do not overload
the vehicle by exceeding the maximum weight
capacity of 55 lbs (25 kg) or by towing anything
behind the vehicle. Running into steep slopes or
fixed objects can cause the wheels to stop spinning
while power is still being supplied to the motors.
Do not make the battery short circuit.
Before
05

located under the main body
be
3.After charging is completed (at least 8-10 hours, but no more than 24 hours, with the first charge
taking about 12 hours), unplug the charger from the wall outlet and unplug the battery connector from
the charger port.
Plug the charger Into a standard wall outlet. The charger may be warm during charging.
Only use the 6/12 volt charger to charge your 6/12 volt battery.
Before first-time use, charge the battery for at least 12 hours. Never charge the battery longer
than 24 hours.
see the following Battery Installation Section for detailed instructions on installing your vehicle.
06

Your battery is a sealed lead-acid battery It must
be recycled or disposed in an environmentally
manner.
Never dispose your battery in the regular,
household trash. The incineration, land-filling or
mixing of sealed lead-acid batteries with
household trash is prohibited by law in most areas.
Always remove exhausted batteries from your toy.
Dispose of dead batteries properly. Never burn or
bury them.
Do not dispose of a lead-acid battery in a fire. The
battery may explode or leak.
07

Decoration
08
Handlebar
Nut×2（M8）

Assemble all parts in sequence as the
picture shows, insert the wheel in the
rear axle and then pad the washer,
fasten the nuts with socket tools for two
sides at the same time. Press the
motor cover decorations until hearing
crack sound.
assemble
09

Take out the handlebar, place it onto the turning
shaft and fasten it with bolt and nut (M5).
9
9
78
7
10
Handlebar