Creality CR-100 Manual

CR-100 Guide Book
本说明书依据CR-1003D打印机编制而成
This guide book is for standard CR-100.
详细使用指南见TF卡
Detailed instructions for user are available on the TF card.
Screen
Button board
USB port
Power port
TF Slot
Extuder
Holder
Nozzle
Power Switch
Parameter
Model CR-100
MoldingTech.FDM
PrintingSize 100*100*80mm
PrintingSpeed ≤180mm/s，Normal 30-60MM/S
Precision ±0.1mm
LayerThickness 0.1-0.4mm
NozzleDiameter 0.4mm
Nozzle Temp. 200℃
PrintingMode TF card One-button Print，offline printing, Remote printing
FileFormatstl，obj，amf
SliceSoftwareCreality Slicer/Cura/Simplify3D
PowerSupply Input:100-240V AC 1.2A 50/60Hz
Output:DC 12V 5.0A
Total Power60W
Filament φ1.75mm PLA

Function Description
Installation Holder
Filament
1. Insert the holder into the mounting hole then turn it to
the right to lock it.
2. Put the filament on the holder.
Start/Pause：
First Click ：Start to Printing after
heating to 200℃
Second Click：Stop printing
Third Click：Continue Printing
Home：Return to origin
Heat/Cool：
First Click：Heating to 200℃。
Second Click：Stop to heat,
Cooling to room
temperature
Remote Control Button Panel
Load Filament
Filament
Clip
Clip
Magnetic Platform
Platform
Place the magnetic platform on the printing
platform, and fix it by clips.
1. Pressing to heat，waiting the tempreature of nozzle to arrive 200℃.
2. Pressing the extrusion clamp, pass the filament through the extruder and
PTFE tube into the nozzle, untill the filament overflow
*After heating, Press the extrusion clamp, pull out the filament to remove.
Load Filament
Install Platform
1. Insert the TF card into the TF slot of
the printer
2. Click to wait for the nozzle to
heat up to 200 ° C
3. Model will be printed after 2 minutes
* It only will print the first model in
the TF card
TF
Note
In case ofemergency, please turnoffthe power ofthe
3D printer directly.
Please use a3D printer in aspacious, level, and well
ventilated environment.
It is recommended that using printer in the temperature
of8℃-40℃and ahumidity of20%- 50%. outside this
range may result in poor printing results.
Do not disassemble the 3D printer without permission.
Ifyou have anyproblems, please contact：
[e-mail]
Run “User Guide” in the TF card for more usage
information.
TF
One-button Print