CREE LIGHTING IG Series User manual

IG Series
LED Luminaire
Bird Guard
1 of 2 LPN00623X0001A0_B
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
TO INSTALL:
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant
l’installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
BIRD GUARD MOUNTING
STEP 1:
Bring both halves of the bird guard together around the pendant as shown in Figure 1 and 2. Make sure that the flanges go under the non flange sides
This is needed for proper securing of the screws in the next step.
NOTE: There is one flange side on each half of the bird guard.
1 2
Flange

2 of 2 LPN00623X0001A0_B
www.creelighting.com
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree®and the Cree logo are
registered trademarks of Cree, Inc.
3
STEP 2:
With the bird guard mounting tabs
resting on top off the fixture, secure
the bird guard halves together
using (4) provided screws as
following (See Figure 3):
• Two screws are inserted in
on the sides of the bird guard
assembly, make sure that the
flange side of the bird guard is
underneath the non flange side.
• Two screws are inserted through
the top two tabs. Ensure that the
screws are inserted through the
round hole.
NOTE: Inserting the screw
initially from the opposite side
(the slot) will not allow the screw
to fasten properly.
STEP 3:
Push bird guard assembly
downwards to fully engage
mounting tabs with top of the IG
luminaire. See Figure 4.
Top Tabs
Slot
4
Mounting Tabs
Mounting Tabs
Round
Hole