> 2-way RF wireless transceiver/gateway
> infiNET™ mesh network technology
> Dynamic discovery for fast, easy setup
> "Wi-Fi friendly" channel selection for trouble-free operation
> Up to 150 foot range indoors, 250 feet outdoors
> Supports up to 30 infiNET devices
The C2N-MNETGW is a 2-way RF gateway/transceiver designed to enable
communications and management for a complete infiNET wireless network of
dimmers, thermostats, and other devices. The C2N-MNETGW links the infiNET
network to the Cresnet wired network to enable communications with a 2-Series
control system.
infiNET™—Crestron's groundbreaking infiNET wireless technology provides
reliable 2-way communications throughout a home or office structure without the
need for physical control wiring. Employing a 2.4 GHz mesh network topology,
every infiNET device functions as an RF repeater, increasing effective range and
reinforcing the complete network by providing multiple redundant signal paths
within the mesh network. Adding more infiNET devices or repeaters to the network
effectively increases the range, strength, and reliability of the network.
Up to 30 infiNET dimmers, switches, and other devices can be linked to a control
system via a single C2N-MNETGW gateway. Additional gateways may be installed
to support additional devices, with up to 16 gateways possible in a complete
system (RF conditions allowing).
Easy Setup—Setting up a complete infiNET network is simple, utilizing dynamic
discovery to locate and acquire each RF device automatically. Every device
assigned to a common gateway automatically behaves as a repeater for any other
devices within range (approximately 150 feet indoors), and additional repeaters
may be added if necessary. At all times, the C2N-MNETGW monitors each device
on the network, ignoring any other 2.4 GHz signals, and reconfiguring the entire
network automatically in response to new sources of interference and other
changes in RF conditions.
SPECIFICATIONS
Wireless
RF Transceiver: 2-way RF, 2.4 GHz ISM Channels 11-26 (2400 to 2483.6 MHz),
IEEE 802.15.4 compliant
RF Transmitting Power: 10 mW
Range (typical): 150 feet indoor, 250 feet outdoor, subject to site-specific conditions;
range is increased by adding additional devices or C2N-MNETRPT repeater
Controls
ACQUIRE: (1) Recessed pushbutton with red LED, used to configure the wireless network
SETUP: (1) Recessed pushbutton with red LED, used for touch-settable ID (TSID)
LED Indicators
PWR: (green) Indicates DC power supplied from Cresnet network
NET: (yellow) Indicates communication with the Cresnet system
RXD: (red) Indicates data is being received from wireless network devices
TXD: (red) Indicates data is being transmitted to wireless network devices
Connectors
NET: (1) 3.5mm detachable terminal block, Cresnet slave port
Connects to Cresnet control network
Power Requirements
Cresnet Power Usage: 3 Watts (0.125 Amps @ 24 Volts DC)
Enclosure
Black metal, freestanding or surface mount
Environmental
Temperature: 32° to 104°F (0° to 40°C)
Humidity: 10% to 90% RH (non-condensing)
Dimensions (Without antenna)
Height: 1.24 in (3.15 cm)
Width: 2.47 in (6.28 cm)
Depth: 3.88 in (9.85 cm)
Weight
8.3 oz (0.24 kg)
AVAILABLE ACCESSORIES
C2N-MNETRPT infiNET Repeater
Crestron C2N-MNETGW
infiNET™Gateway
3.62 in
(9.18 cm)
1.24 in
(3.15 cm)
2.47 in
(6.28 cm)
3.88 in
(9.85 cm)
Left Side
www.crestron.com
|
800.237.2041
Specifications subject to change without notice. Doc.4837 12/07
©2007 Crestron Electronics, Inc. All brand names, product names and trademarks are the property of their respective owners.
Crestron Electronics, Inc.
15 Volvo Drive
l
Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400
l
Fax: 201.767.1903
FrontTop
Back
