Crestron CNWM-10A User manual

CRESTRON CNWM-10A Wall-Mount Wired Panel
REMOTE CONTROL SYSTEMS
1 DOC. 8001B
Specifications subject to change without notice.
109
87
65
43
21
CRESTRON
4.62 in
11.73 cm
2.86 in
7.26 cm
Panel installs in 1-gang electrical box (2.50 in (6.35 cm) minimum depth).
SYNTAX:
NET.ID <10 to FE>: CNWP
i1,o1 = <signal name> \ button and LED combined
i2 = <signal name> \ independent button
o2 = <signal name> \ independent LED
" = " "
" = " "
i10 = <signal name>
o10 = <signal name>
DESCRIPTION:
The CNWM-10A wired panel interfaces to a CRESNET II control system over the CRESNET II network. The panel uses 10
miniature pushbuttons with self-contained feedback LED's. The CNWM-10A is designed for wall-mounting using a standard
single-gangelectricalbox.Custompanelfinishes,engraving,coloredbuttoncaps,andtheomissionofunusedbuttonsareall
standard.
Eachunique panel or component on the CRESNET IInetworkrequiresthe setting of an identity code (ID CODE).IDCODESare
two-digithexadecimalnumbers,from10toFE.TheIDCODEofthepanelshouldbesettomatchtheIDCODEspecifiedinthe
NET.IDstatement of the CRESNET II SIMPL-C program referencing the panel (see syntaxabove).TosetanID CODE, remove
thepanelfromtheelectricalboxanddisconnectpower.

CRESTRON CNWM-10A Wall-Mount Wired Panel
REMOTE CONTROL SYSTEMS
2 DOC. 8001B
Specifications subject to change without notice.
Accessible through the back plate are two miniature circuit-mounted rotary switches, identified as H and L. These 16-
position hexadecimal switches can be set to 0 through F. Using a small screwdriver, rotate the arrow in the center of the
switch marked H to point to the first (or most-significant) digit or letter of the specified ID CODE. Set the switch marked L to
the second (least-significant) digit or letter of the specified ID CODE.
The 4-pin connector marked NET should be wired to the CRESNET II network. Network termination points are available at
the control system power supply. Network units may also be daisy-chained together. Refer to the latest revision of the
CRESNET II reference manual section on CNPWS power supplies (Doc 8017 or Doc. 8091) for wire gauge specifications and
connectiondetails.
Thepaneldrawingon the previous page shows the location of the SIMPL-C button numbers and their corresponding button
positions.Buttonswhicharenotusedneednotbeassignedasignalname.
Asofthedateofmanufacture,theunithasbeentestedandfoundtocomplywithspecificationsforCEmarking.
REQUIRES:
CRESNET II Workshop Version 4.00 or later.
CRESNET II Operating System SR30160.OPS or later.
FURTHER INQUIRIES:
If after reviewing this information you still have additional questions, please contact a CRESTRON technical support
representative by dialing (888) CRESTRON [[phone]] or [phone].