Crestron CNIRHT-MM Technical manual

Crestron CNIRHT-MM 30 Function Hand-Held IR Transmitter
Addendum #1 for DOC. 8171 30 Function Hand-Held IR Transmitter: CNIRHT-MM
30 Function Hand-Held IR
Transmitter: CNIRHT-MM
Overview
This document provides updated and/or new information for the 30 Function Hand-Held IR
Transmitter. This information pertains specifically to the CNIRHT-MM Operations Guide,
Doc. 8171, dated 06.01. For the document number and date, refer to the bottom-right corner
of the rear cover of the original guide.
Purpose
This addendum provides information that has been revised to the “Set or Display Transmitter
ID via Keypad Buttons” procedure, which begins on page 4 of the guide.
The first sentence of step 3 of the procedure is currently published as follows:
3. To establish a “0” key for displaying or setting the Transmitter ID, press and
hold any button for at least five seconds while re-connecting the battery.
Instead of pressing and holding ANY button, which can occur inadvertently while replacing
the battery, only the PWR button may be used to establish a “0” key. The sentence is revised
as follows:
3. Refer to the diagram below. To establish a “0” key for displaying or setting
the Transmitter ID, press and hold the PWR button for at least five seconds
while re-connecting the battery.
Transmitter PWR Button
PWR MUTE - VOL +
NOTE: The remainder of step 3 and procedure is unchanged.