Crestron DigitalMedia 8G+ DM-TX-4KZ-100-C-1G User manual

The Crestron® DM-TX-4KZ-100-C-1G is a DigitalMedia 8G+® wall plate
transmitter that supports 4K60 4:4:4 and HDR (High Dynamic Range)
video. The transmitter provides a cost-effective solution for a single AV
source as part of a complete Crestron DigitalMedia™ system.
In the Box
1 DM-TX-4KZ-100-C-1G DigitalMedia 8G+® Wall Plate
Transmitter
Additional Items
1 Bracket, Surface Mount (2016054)
1 Connector, 2-Pin (2003574)
1 Connector, 3-Pin (2003575)
2 Screw, 6-32 x 3/4 in., Truss Head, Combo (2009211)
2 Screw, 6-32 x 1/4 in., Pan Head, SEMS (2007218)
Install the Transmitter
Mount the transmitter into an electrical box, onto a flat surface, or onto a
rack rail. Connect the rear of the transmitter before mounting it into an
electrical box. If the transmitter is to be mounted onto a flat surface or
rack rail, connect the rear of the transmitter after the device is mounted.
Connecting the Rear of the Transmitter
NOTE: The DM OUT port is a PoDM (Power over DM) powered device
(PD) port and is also compatible with HDBaseT® PoE:
lIn order for the DM OUT port to receive PoDM, the port must be
connected to a DigitalMedia switcher or other DigitalMedia
equipment that has a PoDM power sourcing equipment (PSE) port.
lIn order for the DM OUT port to receive HDBaseT PoE, the port
must be connected to equipment that has an HDBaseT PoE PSE
port.
Wiring that connects to a PoDM or HDBaseT PoE port is designed for
intrabuilding use only.
PoDM, HDBaseT PoE, or the optional PW-2407WUL power pack
(soldseparately) can be used to power the transmitter.
Connections to Rear of Transmitter
1
DM-TX-4KZ-100-C-1G QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Wall Plate Transmitter

Mounting into an Electrical Box
Mount the transmitter into a 1-gang electrical box (not included).
1. Using a Phillips screwdriver and the two included 6-32 x 3/4-inch truss
combo head screws, attach the transmitter to the electrical box.
2. Attach a decorator style faceplate (not included) to the transmitter.
The optional Crestron FP-G1 Series faceplate assembly, which is
shown in the illustration below, is sold separately.
Mounting into an Electrical Box
Mounting onto a Flat Surface
Mount the transmitter onto a suitable flat surface such as the underside
of a table.
1. Using a Phillips screwdriver and the two included 6-32 x 1/4-inch
SEMS screws, attach the included surface-mount bracket to the
transmitter.
2. Attach the bracket to the flat surface using the two surface-mount
screw slots and two mounting screws (not included).
Mounting onto a Flat Surface
2
DM-TX-4KZ-100-C-1G QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Wall Plate Transmitter

Mounting onto a Rack Rail
Mount the transmitter onto the front or rear rail of a rack.
1. Position the transmitter horizontally so that the holes in the left or
right mounting flange align with the holes in the rack rail.
2. Secure the unit to the rack rail using two mounting screws
(notincluded).
Mounting onto a Rack Rail
Connecting the Front of the Transmitter
Connect the front of the transmitter as required for the application.
NOTES:
lThe IR OUT and COM ports are enabled only when the transmitter
connects to an Ethernet-enabled DigitalMedia switcher or receiver
that is addressable from a Crestron control system.
lPass-through mode for RS-232 and CEC is supported.
Foradditional information, refer to Online Help Answer ID 1000497
on the Crestron website (www.crestron.com).
Connections to Front of Transmitter
3
DM-TX-4KZ-100-C-1G QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Wall Plate Transmitter

Observe the LED Indicators
LED indicators are provided on the front of the transmitter. The DM OUT
port, which is located on the rear and can be viewed from the top of the
transmitter, also includes LED indicators.
LED Indicators (Front and Top Views Shown)
Refer to the following table for information about the LED indicators.
LED
Indicator Color Meaning
POWER Green Power is being applied to the device.
VIDEO Green A video signal is detected at the HDMI input.
DM
OUT
(Rear)
Green A DM link is established.
Solid
amber
HDCP video is detected.
Blinking
amber
Non-HDCP video is detected.
Visit the Product Page
Scan the QR code to visit the product page.
DM-TX-4KZ-100-C-1G-B-T
www.crestron.com/model/6510626
DM-TX-4KZ-100-C-1G-W-T
www.crestron.com/model/6510627
4
DM-TX-4KZ-100-C-1G QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Wall Plate Transmitter

Additional Information
Original Instructions
The U.S. English version of this document is the original instructions.
All other languages are a translation of the original instructions.
Crestron product development software is licensed to Crestron dealers and Crestron
Service Providers (CSPs) under a limited nonexclusive, nontransferable Software
Development Tools License Agreement. Crestron product operating system software is
licensed to Crestron dealers, CSPs, and end-users under a separate End-User License
Agreement. Both of these Agreements can be found on the Crestron website at
www.crestron.com/legal/software_license_agreement.
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit
www.crestron.com/opensource.
Crestron, the Crestron logo, DigitalMedia, DigitalMedia 8G+, and DM 8G+ are either
trademarks or registered trademarks of Crestron Electronics, Inc. in the United States
and/or other countries. HDBaseT and the HDBaseT Alliance logo are either trademarks
or registered trademarks of the HDBaseT Alliance in the United States and/or other
countries. HDMI and the HDMI logo are either trademarks or registered trademarks of
HDMI Licensing LLC in the United States and/or other countries. Other trademarks,
registered trademarks, and trade names may be used in this document to refer to
either the entities claiming the marks and names or their products. Crestron disclaims
any proprietary interest in the marks and names of others. Crestron is not responsible
for errors in typography or photography.
©2020 Crestron Electronics, Inc.
Doc. 8543B
04/16/20
5
DM-TX-4KZ-100-C-1G QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Wall Plate Transmitter