Cretors E1202 User manual

176 MITTEL DRIVE, WOOD DALE, IL 60191
Models: E1202
Nacho Pequeño
Display Cabinet Manual
100 Volt, Single Phase, 50/60 Hz
120 Volt, Single Phase, 60 Hz (-A)
230 Volt, Single Phase, 50 Hz (-E)
READ and UNDERSTAND these operating and safety
instructions before operating this Cretors machine

Display Cabinet Manual
Revised 11.10.17
2
TABLE OF CONTENTS
I. Safety Alert Symbol................................................................................... 3
II. Safety First................................................................................................ 3
III. Introduction................................................................................................ 3
IV. Purpose of Manual .................................................................................... 4
V. Product Identification................................................................................. 4
VI. Principles of Display Cabinet Operation..................................................... 4
VII. Control Switch ........................................................................................... 4
VIII. Installation Instructions.............................................................................. 4
IX. Operating Instructions ............................................................................... 5
X. Sanitation Instructions ............................................................................... 5
XI. Service Instructions ................................................................................... 6
XII. Troubleshooting......................................................................................... 6

Display Cabinet Manual
Revised 11.10.17
3
I. SAFETY ALERT SYMBOL
The symbol shown is used to call your attention to instructions concerning your personal safety and
the safety of others. Watch for this symbol. It points out important safety precautions. It means
ATTENTION! Be Alert! Your personal safety is involved! Read the message that follows and
be alert to the risk of personal injury or death.
II. SAFETY FIRST
The information in this manual is essential for the safe installation and
operation of your Cretors machine. The manual must be read and
understood before installing, and operating the equipment, or equivalent
training must be provided.
The employer shall instruct each employee in the recognition and avoidance
of unsafe conditions, as well as, the regulations applicable to his work
environment and to control or eliminate any hazards or other exposure to
illness or injury. Ref.: 29 CFR 1926.20 (b)(4)(a)(2)
It is understood that safety rules within individual companies vary. If a conflict
exists between the safety procedures contained in this manual and the rules of a
using company, the more stringent rule should take precedence.
III. INTRODUCTION
This manual is filled with time-saving and money-saving information regarding your unit. There is
nothing more important than the safety aids and warnings that are throughout this document. The
Safety Alert Symbol is used to identify topics of primary safety concern wherever they appear.
If, after reviewing this manual, anything is unclear or technical problems are encountered, contact
the distributor from whom you purchased your unit for assistance or contact our Customer Service
Department at [phone]. Always have the model and serial number of your unit available to
assist in obtaining the correct information.

Display Cabinet Manual
Revised 11.10.17
4
IV. PURPOSE OF MANUAL
This instruction manual is intended to familiarize owners with the operation and safety
procedures associated with the unit.
It is important that this manual be kept available to operating personnel.
V. PRODUCT IDENTIFICATION
CRETORS POPCORN AND NACHO DISPLAY CABINET
MODEL
NPA_-X; NPE_-X –DISPLAY CABINET
REF. (1202-A/1202-E –DISPLAY CABINET)
Electrical:
100 Volt, 50/60 Cycle, 160 Watts
120 Volt, 60 Cycle, 160 Watts
230 Volt, 50 Cycle, 160 Watts
VI. PRINCIPLES OF DISPLAY CABINET OPERATION
Theory and Observations of Display Cabinet Operation
The Display Cabinets hold nacho chips, popcorn, or other snacks on racks to maximize the sell
ability of snacks. Load and un-load product through the large door on the unit’s front. The unit
features a corrosion-resistant design and tempered glass for easy cleaning; the surface will not
scratch or discolor. The unit’s door is easily-removable, for cleaning. Rubber feet prevent
skidding on counter top surfaces. The cabinet is provided with two lights and a heat pad to
keep product warm.
VII. CONTROL SWITCH
MAIN POWER SWITCH -Controls light and cabinet heat.
VIII. INSTALLATION INSTRUCTIONS
1. Location
Choose a location for your unit to maximize the ease of operation and maintenance
procedures. Check your local building and fire codes for location restrictions.
2. Power Supply
Check the nameplate to determine the required power supply.

Display Cabinet Manual
Revised 11.10.17
5
Connect the unit only to the correct power source.
Make certain the main power switch on the cabinet is in the 'OFF' position when
plugging into power source.
3. Install the racks
Install the clips in all four corners at the same height, as desired. The unit is provided with
two (2) racks and eight (8) clips which can be installed to accommodate different size
packaging.
IX. OPERATING INSTRUCTIONS
Do not attempt to operate the unit until you have read and understood this manual.
Failure to do so may result in serious injury or death.
Do not attempt to operate your unit unless the installation instructions have been strictly
adhered to. Failure to do so may result in serious injury or death.
Operate the unit only if it is in sanitary condition (SANITATION INSTRUCTIONS).
Failure to do so may result in illness to your customers.
1. Turn on rocker switch to turn on light and heat pad.
2. With racks already installed at desired height, load unit with product. Do not overfill the
cabinet.
3. Dispense product through the front door. Door can be installed on opposite side to open
opposite direction.
X. SANITATION INSTRUCTIONS
Be certain the unit is turned off and the power is unplugged before sanitizing, unless a
specific cleaning procedure requires power to the machine. Failure to do so could
result in serious injury or death.
Do not clean heated surfaces until they have been given sufficient time to cool.
Failure to do so may result in serious burns or scalds.
Do not immerse the unit in water. This will damage the electrical components, and may
cause short circuits, resulting in an electrical shock hazard if power is applied.

Display Cabinet Manual
Revised 11.10.17
6
1. After unit has been allowed to cool and has been unplugged, remove any excess
product remaining in the bottom.
2. Clean all surfaces with a non-abrasive food safe cleaner.
This appliance should not be cleaned with a water jet.
XI. SERVICE INSTRUCTIONS
Only a qualified person should perform the following diagnostic checks, and, if
necessary, corresponding adjustments and repairs. Many of the following procedures
may present an electrical shock hazard and can cause serious injury or death.
Perform work only on de-energized circuits. Failure to do so may lead to electrical
shock resulting in personal injury or death.
A. Parts
When ordering parts, refer to the recommend spare parts list included with this manual
or wiring diagram. Always supply the serial number and model number of the unit.
B. Check Unit Periodically
Periodically check electrical switch and cord for signs of wear. Check all screws and rivets
for tightness.
C. To Access Electrical Components
To access all electrical components, unplug power cord from outlet, and then lay unit on its
side and remove the four screws from the bottom cover, exposing heating element, switch,
and wiring. THIS UNIT IS NOT FUSED.
D. Troubleshooting
PROBLEM
POSSIBLE CAUSE
ACTION
Unit will not heat.
Unit unplugged or not switched
on.
Plug unit in. Turn on power.
Loose connection to heater.
Repair connection.
Light will not work.
Unit unplugged or not switched
on.
Plug unit in. Turn on power.
Bulb burned out.
Replace bulb with
recommended replacement
part (#EP2053-220)
RECOMMEND SPARE PARTS LIST
PART DESCRIPTION
PART NUMBER

Display Cabinet Manual
Revised 11.10.17
7
DOOR HINGE
EP4866
LIGHT BULB
EP2053-220
CLIP
16807
RACK
16810
DOOR
EP1904
KNOB
EP4539
MAGNET
EP1820
This unit is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the use of the unit by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the unit.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
If you have questions regarding the operation or cleaning of your unit, contact your local distributor
or the Customer Service Department at C. Cretors and Company at [phone].
Cretors guarantees this machine to be free of defects in parts, materials and workmanship for two
years. Please fill out the factory registration card and return it to activate your warranty. If you have
questions concerning the Cretors’ warranty, please contact your local distributor or the Customer
Service Department at C. Cretors and Company.
C. CRETORS AND COMPANY
176 MITTEL DRIVE
WOOD DALE, IL 60191
PHONE [phone], FAX [phone]
WEB SITE: http://www.cretors.com Email: [e-mail]