Crosley Bates CO1024 User manual

IMPORTANT NOTE: WE RECOMMEND AT LEAST TWO PEOPLE WORK
TOGETHER TO ASSEMBLE UNIT.
17 27 56
84

Screw adjustable levelers (part #7) into pre-drilled holes on the bottom of legs (parts A & B).
Attach leg support (part C) to legs (parts A & B) using short bolts (part #3), metal washers (part #5), self-locking
nuts (part #4), wrench (part #9) and allen wrench (part #10).

Attach supports (part D) to legs (parts A & B) and leg support (part C) using short bolts (part #3),
metal washers (part #5), self-locking nuts (part #4), wrench (part #9) and allen wrench (part #10).

5
10
Attach back panel (part H) to seat panel (part I) using medium bolts (part #2), short bolts (part #3), metal washers
(part #5), self-locking nuts (part #4), wrench (part #9) and allen wrench (part #10).

Figure 1
Figure 2
Figure 1
Figure 2
Install long bolts (part #1), metal washers (part #5), connecting screws (part #8) and self-locking nuts (part #4) to back
nuts (part #4), wrench (part #9) and allen wrench (part #10). Ensure assembled unit (parts H & I) is tilted at an angle to
panel (part H) using wrench (part #9) and allen wrench (part #10). See Figure 1. Ensure connecting screws (part #8)
are on the back of back panel (part H) and sticking out. See Figure 2. Next, connect arms (parts F & G) to assembled
unit (parts H & I) using installed connecting screws (part #8), short bolts (part #3), metal washers (part #5), self-locking
line up properly with arms (parts F & G).
NOTE: Please do not fully tighten bolts until unit is fully assembled.

Attach hooks on arms (parts F & G) to swing arms on legs (parts A & B) using long bolts (part #1), metal washers
(part #5), plastic washers (part #6), self-locking nuts (part #4), wrench (part #9) and allen wrench (part #10).
Using at least two people, carefully lift assembled unit (parts F, G, H & I) and place inside assembled unit
(parts A, B, C & D).

Attach connecting wire (part E) to arms (parts F & G) using metal washers (part #5), self-locking nuts (part #4) and
wrench (part #9).
Attach connecting wire (part E) to arms (parts F & G) using metal washers (part #5), self-locking nuts (part #4) and
wrench (part #9).