Cypress Semiconductor CY3215-DK User manual

CY3215-DK PSOC®IN-CIRCUIT EMULATOR DEVELOPMENT KIT
QUICK START GUIDE
Install Software
1. Insert the CY3215-DK CD into the CD
drive of your PC.
2. Install the kit contents, PSoC Designer,
and PSoC Programmer.
Note: You can also downlad the latest
software and documents from
http://www.cypress.com/go/CY3215-DK.
Use MiniEval to Evaluate
1. Attach the flex cable and pod to the
ICE-Cube (ICE base unit).
2. Plug the 28-pin feet to the pod and
connect the MiniEval board via the ZIF
socket.
3. Create a project in PSoC Designer and
start debugging.
Use MiniEval to Program
1. Attach the backward compatibility
adapter to the ICE-Cube in the place
of the flex-pod.
2. Connect the RJ45 end of the ISSP
cable into the adapter.
Use MiniEval to Program
3. Insert the IC on the ZIF socket.
4. Connect the 5-pin connector of the ISSP
cable to the MiniEval.
5. Program the parts using PSoC
Programmer.
1
2
3
4

© 2010-2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. DOC#: 001-64232 REV. *B
http://www.cypress.com/go/CY3215-DK
For the latest information about this kit, visit
CY3215-DK PSOC® IN-CIRCUIT EMULATOR DEVELOPMENT KIT
QUICK START GUIDE
CY3215-DK Kit Details
ICE Base Unit ISSP Cable
USB 2.0 Cable
CY3250 Flex Cable
29000-28
PDIP Kit 12-V 1-A Adapter
MiniEval Board
Blue Cat 5e Cable
Backward Compatibility
Adapter
ZIF Socket
2 Units of 28-Pin
DIP Samples
(CY8C29466-24PXI)