D-Link mydlink DNR-202L Manual

Technical Support Setup Procedure
Page | 1
How to enable or disable manual recording of DNR-202L?
Note: You may download :
-required Firmware
-run the suitable OS wizard setup rom http://sg.mydlink.com/support which will display the
current IP address assigned to the device rom your router:
Locate and run the downloaded Setup Wizard on your computer. Click on START to proceed.

Technical Support Setup Procedure
Page | 2
Ensure that the network ports, HDD(s) and corresponding devices’ power adaptors are connected
and are powered on. Click Next till the current IP address is displayed next to the desired DNR-202L.

Technical Support Setup Procedure
Page | 3
Step 1: Open an Internet browser (such as Internet Explorer) and enter http://< IP Address> into the
address bar.
Step 2: Enter your login in ormation. I you have not changed the de ault settings, the username is
Admin and the password ield should be le t blank. Click Login.
Note :
- Manual record is enabled the manual record button will be RED and
- Manual record is disabled the manual record button will be BLA K.
Step 3: Click on manual record button to enable/disable manual recording.
--- END ---