Daintree GE current Proline LEX Series User manual
Installation Guide
IND677
Proline®LEX Series
LEX Exit Sign
BEFORE YOU BEGIN
• READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
• RISK OF ELECTRIC SHOCK—NEVER CONNECT TO,
DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT
IS ENERGIZED.
• FAILURE TO FOLLOW THESE INSTRUCTIONS AND
WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE—
For your protection, read and follow these warnings and
instructions carefully before installing or maintaining this
equipment. These instructions do not attempt to cover
all installation and maintenance situations.
IMPORTANT SAFEGUARDS
•
accordance with the applicable installation codes by a person familiar with the construction operation of the product
and hazards involved.
• This product must be installed in accordance with the applicable installation codes and ordinances.
•
• Disconnect A.C. power and unplug battery before servicing.
• Consult your local building code for approved wiring installation.
•
• Do not let power supply cord touch hot surfaces.
• Do not mount near gas or electric heater.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause unsafe condition.
• Do not use this equipment for other than intended use.
•
other voltage.
Save These Instructions
Deliver to owner after installation.
2
Proline® LEX Series Exit Sign Installation Guide
Wall Mount Installation
1
2 Remove lens from sign, set aside.
3 Remove EXIT stencil from housing, set aside.
4
6
7
8
9
10
11 Secure face plate to the housing.
12
13
5
3
Proline® LEX Series Exit Sign Installation Guide
Ceiling or End Mount Installation
1
2 Remove lens from sign, set aside.
3 Remove EXIT stencil from housing, set aside.
4
5Using provided hardware, thread nut onto pipe nipple. Slide pipe nipple through canopy hole.
6
7
8
9
13
10
14
11 Secure canopy to steel mounting plate with screws installed in step 7.
15 Secure face plate to the housing.
12
16
17
4
Proline® LEX Series Exit Sign Installation Guide
location on the top or side of the frame of the sign.
1
FLEXIBLE CONDUIT ONLY!
Conduit Entry
Route the AC input conduit into housing.
2
All conduit connections must use UL LISTED and SUITABLE
FOR WET LOCATION parts.
3
Wall, Ceiling
or End Mount instructions.
4
Operation (Battery Back-up)
1Apply AC power to the unit. The LED indicator will be RED. Plug battery into the board and the LED indicator
will turn Green.
2
turns OFF and the LED board stays ON.
3 When the switch is released, the LED indicator will turn to GREEN and the LED board remains ON.
www.gecurrent.com
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
Proline® LEX Series Exit Sign Installation Guide
Maintenance
CAUTION
BATTERY
The battery supplied with the EM model requires no maintenance. However, it should be tested periodically
Battery
Transformer
RED 277VAC
BLACK 120VAC
WHITE COMM
LED BOARD
Transformer
LED BOARD
RED 277VAC
BLACK 120VAC
WHITE COMM
LED BOARD
RED 277VAC
BLACK 120VAC
WHITE COMM
RED 277VAC
BLACK 120VAC
WHITE COMM
Transformer Transformer
LED BOARD
Battery Back-up Wiring Diagram AC Only Wiring Diagram
Dual Circuit Unit
Table of contents
Other Daintree Lighting Equipment manuals
Daintree
Daintree GE GEXNLG15 User manual
Daintree
Daintree GE Current Arize Life2 User manual
Daintree
Daintree GE Current Tetra GEPS12-25U-NA User manual
Daintree
Daintree GE Tetra miniMAX User manual
Daintree
Daintree GE current Lumination LRX Series User manual
Daintree
Daintree GE Forum Frame IND739 User manual
Daintree
Daintree Contour Gen 2 Flex User manual
Daintree
Daintree GE Current Arize Factor User manual
Daintree
Daintree GE current Evolve EFC1 Series User manual
Daintree
Daintree GE Current UltraMax GED80MCC/Z2P1500 User manual
Daintree
Daintree GE Current RAIL159 User manual
Daintree
Daintree GE cirrent Tetra Rigid Light Bar User manual
Daintree
Daintree GE current Tetra PowerStrip Snap DS User manual
Daintree
Daintree RM4 User manual
Daintree
Daintree GE current Lumination RC Series User manual
Daintree
Daintree GE Current Tetra GEPS24-25U-NA User manual
Daintree
Daintree GE Current Lumination LRXD Series User manual
Daintree
Daintree GE Tetra MAX User manual
Daintree
Daintree GE Tetra Atom User manual
Daintree
Daintree GE current Tetra Contour User manual
