Dakota Digital VHX-63J-WAG User manual

Manual # 650787
VHX-63J-WAG
Dakota Digital VHX Instrument Installation
For 1963-72 Jeep Wagoneer, 1963-72 J-Trucks
and 1967-72 Jeepster Commando
Your new VHX-63J-WAG kit includes:
VHX Display
Universal Sender Pack
Installation Manuals
Control Box
36” CAT5e Cable
4x Nylon
Thumb Nuts
Switch
Assembly
2x Short
Brackets
2x Long
Brackets

Manual # 650787
Installation
1. Remove the factory instrument cluster by disengaging the four spring clips securing the instrument
cluster to the dash. No components from the original cluster will be reused, and it may be set aside.
2. Carefully insert the new VHX system into the front of the dash. From the back side, place the two
provided Short Brackets on the top studs, and the two Long Brackets on the bottom studs. Firmly
tighten the brackets down with the provided Nylon Thumb Nuts.
3. Attach the provided 36” CAT5e Cable to the back of the VHX system. Carefully run the other end of this
cable to the control box mounting location. Refer to the main VHX manual for wiring instructions to
complete the installation.
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov