Dakota Digital RTX-55C User manual

Manual # 650641
RTX-55C
Dakota Digital RTX Instrument Installation
For 1955-‘56 Chevy car
Your new RTX-55C kit includes:
Installation
Control Box
6x Lock Washers
6x Screws
Main Harness
Universal Sender
Pack
Installation Manuals
RTX Display
1. Remove the stock instrument cluster from the car.
Block Off Lens
(For Automatic Bezels)
Foam Tape
Buzzer
Switch Assembly

Manual # 650641
2. Remove the six screws holding the gauges to the bezel
from the back of the system, so the stock gauges,
separator plate, and lens can be removed.
3. For automatic applications, remove the gear position indicator
and lens by removing the two screws holding it to the bezel.
4. If you have an automatic bezel, attach the provided block off plate with silicone; the stock gear
position indicator will not fit with the RTX system.

Manual # 650641
6. Secure the RTX system to the bezel with the
six (6) screws and lock washers provided.
5. Next, cut the supplied foam into four small pieces, approximately 1” long, and install four foam
blocks into the bezel to help prevent any rattles of the lens and bezel. The foam should sit down in
the bezel and adhere to the outer edge, sticking up about 1/8” so it will compress against the lens
once the system is installed.
Foam
7. Connect the provided harness and
the buzzer (optional for audio
feedback) to the back of the RTX
system.
Buzzer Connector

Manual # 650641
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
8. Re-install the gauge cluster to the dash using the factory hardware and refer to the main manual for
wiring instructions to complete the RTX installation.