Dakota Digital VHX-1019 User manual

Manual # 650418A
VHX-1019
Dakota Digital Universal VHX Instrument Installation
Your new VHX-1019 kit includes:
Installation
Control Box
(4x) L-Brackets
and Thumb Nuts
CAT5 Cable
Universal Sender Pack
Installation Manuals
and Cutout Template
VHX Display
1. Use the provided template to mark out the 6 ¾” diameter opening needed to fit the VHX display.
Ensure adequate clearance behind desired mounting location; the display requires approximately 2”
of depth.
Switch Assembly

Manual # 650418A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
2. With the appropriate opening cut, carefully place the VHX display from the front side and attach the
four (4) L-brackets to the back of the display using the provided thumb nuts.
3. Remove the protective film, and then attach the provided CAT5 Cable to the back of the VHX
display. Carefully route the other end to the control box mounting location and refer to the
main manual for wiring instructions.