Dakota Digital VHX-63C-CAD User manual

Manual # 650640
VHX-63C-CAD
Dakota Digital VHX Instrument Installation
For 1963-’64 Cadillac
Your new VHX-63C-CAD kit includes:
Installation
Control Box
(1) 36” CAT5 Cable
(1) 60” CAT5 Cable
Universal Sender Pack
Installation Manuals
VHX Display
1. Remove the stock gauge cluster from the dash and save all hardware for reassembly.
Clock Power Harness
Blackout lens
VLC Clock

Manual # 650640
3. Peel the protective cover off the Blackout Lens and place it over the gear indicator opening with
the protected side facing down and glue it in place using a black RTV silicone or similar to. Let
the silicone fully setup and dry before moving on to the next step to prevent damage to the
Blackout Lens.
2. Looking at the back of the gauge cluster; remove the clock by rotating the clock ¼ turn in a
clockwise direction until the mounting tabs release and the clock can be pushed out. Also remove
and retain the four (4) bolts indicated below to completely remove the stock gauges.
4. Secure the VLC Clock by placing it into the clock bezel opening from the front orientated as shown
below; rotate the clock in a counter-clockwise direction until the mounting tabs lock into place.

Manual # 650640
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
5. Mount the VHX System to the stock bezel using the same hardware from disassembly. Connect the
36” CAT5 cable to the back of the VHX system while the 60” CAT5 cable will connect to the clock as
well as the clock power harness.
6. The cluster is now ready to re-install into the vehicle using stock hardware, take care when
routing the CAT5 cables to the control box mounting location. Refer to the main manual and
the 650462 clock manual for wiring instructions to complete the VHX installation.