Dancing Wings Hobby Sunbird User manual

Sunbird Instruction Manual V2.0 Balsawood Airplane
Suggested Equipment
Motor: MM2212 1100KV
ESC: 20A
Propeller: 8 inch folded propeller
Servos: 9g*4
Battery: 3s 800-1300mAh
Radio≥4CH
Speci�ication
Wingspan: 1600mm
Length: 850mm
Flying Weight≈450-650g
Preparation Tool
F1
F2
F3
F15
F19
F14
F5
F6
F7
1.2
1.3
1.4
1.5
Take down and assemble the
wood pieces of fuselage as per
the following picture,connect
the joints by 502 glue.
Cut the balsa strips with actual
length,assemble them in place
as pitcture shown left;Assemble
in the same way the other side.
Paste the F1 and F2 together,and
fasten the joint with F3.
Paste the F5 and F6 together,and
fasten the joint with F7.
3*4mm balsa strips
1.Fuselage Assembly
Accessories include

Sunbird Instruction Manual V2.0 Balsawood Airplane
F9
F9
F12
F11
F10
F8
F4 F16
F13
Magnet
Magnet
Assemble the tail as per the 1:1 plan,and take care of the straightness of the tail.
Paste the finished board (picture
1.5 above) at the bottom of the
fuselage.
Assemble the cabin cover as
picture shown left.
Paste the cover F4 and F8 as
picture shown left,paste the
servo mount base F16.
Assemble the vertical and horizontal tail at the tail of
the fuselage,connect the two ailerons with U-shape
steel wire.
1.6
1.7
1.8
2.1 2.2
2.3
U-shape steel wire
2.Assembly of Wing and Tail

Sunbird Instruction Manual V2.0 Balsawood Airplane
Assemble the wing as per the 1:1 plan,and take care of the straightness of the wing.
Paste the balsa cover onto the wing.
Assemble the connection part W20,connect and glue the two parts of the
wing together.
Assemble the left and right wing,connect both with the carbon tubes as picture shown below,
glue at the joints.
2.4
2.5
2.6
2.8
W26
W28-1 W28
W20
W27
W27
Paste the W17 on the wing as
picture shown,cut and polish
by knife with curve.
Cut the balsa strips with
actual length,assemble them
in place as pitcture shown
below;Assemble in same way
the other wing.
2.9
2.7

Sunbird Instruction Manual V2.0 Balsawood Airplane
Assemble the wing onto the fuselage,drill
a hole on the wing as per the F17
position,finally fasten the wing with screw.
Paste together the F17 and F18,assemble the nut onto the F18.
F18
F17
3.1
3.2
3.3
3.4
C.G
≈56mm
3.Assembly of Wing and Fuselage
Assemble the finished part (picture 3.2) onto the fuselage.