Datalogic DH60 User manual

DH60 Single Slot Dock
Read this manual carefully before performing any type of
connection from the terminal to a host PC using the
Single Slot Dock.
The user is responsible for any damages caused by
incorrect use of the equipment or by inobservance of the
indication supplied in this manual.
NOTE
Do not attempt to disassemble the Single Slot Dock, as it
does not contain parts that can be repaired by the user.
Any tampering will invalidate the warranty.
NOTE
The Single Slot Dock paired with a DH60 mobile computer builds a
reading system for the collection, decoding and transmission of barcoded
data.
The Single Slot Dock is a USB communication adapter between the
terminal and the host computer.
The Single Slot Dock also functions as a battery charger, both for the
terminal and the spare battery pack. The spare battery can be charged by
inserting it into the slot at the back of the cradle.
Power supply is required for the DH60 to be connected to the cradle and
for battery recharging operations.
Figure 1 –Single Slot Dock General View
Key:
A) Contacts for DH60
B) Power on LED
C) Battery charge status LED
D) Spare battery slot
E) Power supply connector
F) USB connector
822001641 (Rev. A)
MOBILE COMPUTER INSERTION/ REMOVAL
For correct insertion into the cradle, insert the mobile computer from the
top of the cradle through the guide and push it down.
Figure 2 - Mobile Computer Insertion
To remove the mobile computer from the cradle, simply pull it upwards
while holding the cradle firmly down.
Power Supply
Each dock requires a power supply to be connected to mobile computers.
We recommend the power supply 94ACC0087.
-
+
Figure 3 - Power Supply Polarity
LED INDICATORS
Power LED Status Indicator
Color Status
Green Cradle powered
Battery Charging LED Status Indicators
Color Status
Off Battery absent
Red Battery charge in progress
Green Charge completed
USING THE SPARE BATTERY CHARGER
Correctly insert the battery pack into the slot: simply press it into the slot
until the battery latch is automatically closed; charging starts
automatically.
Figure 4
To remove the battery, release the latch on the battery pack.
Figure 5
A
C
B
D
E
F

CONNECTIONS
USB Client Connection
Connect the Single Slot Dock to the host by means of a standard micro
USB cable.
Once the host has been turned on, insert the DH60 into the cradle.
Figure 6 - USB Connection
Key:
A) Host computer
B) Std-A to Micro-B USB 2.0 cable
C) 94ACC0086 DH60 Single Slot Dock
D) Power Supply
TECHNICAL FEATURES
Electrical Features
Power supply * 5.5 VDC ± 5% @ 2.6A
Consumption Max 2.6 A with mobile computer inserted
Spare slot charge time
DH60 Std Battery 3.5h
DH60 High Cap Battery 4h
Communication Features
Interface USB 2.0 version
Physical Features
Dimensions 112 x 138 x 88 mm
4.4 x 5.4 x 3.5 in
Weight (without
connection cables) 210 g / 7.4 oz
Indicators Green power-on LED
Bicolored battery charge status LED
Environmental Features
Working temperature** 0° ~ 45°C / 32° ~ 113°F **
Storage temperature -20° ~ 70°C / -4° ~ 158°F
Humidity 95% without condensation
Electrostatic discharge
EN 61000-4-2 ± 4 KV contact / ± 8 KV air
* Use only DL approved power adapters.
** DH60 (including spare battery) should be charged at an ambient
temperature between 10 ~ 35º C to achieve the maximum charging rate.
Never charge the main device or spare batteries in a closed space
(cabinet) where excessive heat can build up.
REGULATORY COMPLIANCE
This device complies with SRRC and CCC regulations. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This device has been tested and found to comply with the limits for a
Class B digital device.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user‘s authority to operate the equipment.
©2014 Datalogic ADC S.r.l. • ALL RIGHTS RESERVED. • Protected to
the fullest extent under U.S. and international laws. Copying, or altering of
this document is prohibited without express written consent from
Datalogic ADC S.r.l.
Datalogic and the Datalogic logo are registered trademarks of Datalogic
S.p.A. in many countries, including the U.S.A. and the E.U.
DH60 and the DH60 logo are trademarks of Datalogic ADC S.r.l.
All other brand and product names mentioned herein are for identification
purposes only and may be trademarks or registered trademarks of their
respective owners.
A
BD
C