Defiant HC-3712-WH User manual

HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
Quick Reference Guide
HC-3712 Battery Operated Light
Item #1009569682
Model #HC-3712-WH
Installation
IMPORTANT: This guide is a quick reference only for
common features of the product and troubleshooting tips.
Please read and reference the full instruction manual for
installation, safety, and additional information.
□Determine the mounting location – ceiling/
eave or wall mount.
□To remove the mounting plate, rotate the tab on
the mounting plate towards the UNLOCK symbol
until it is aligned with the UNLOCK symbol on
the main body, and pull up on the tab.
□Install 4 x Alkaline “D” 1.5 V batteries (not
included) into the battery compartment. Ensure
the polarity (+ & - ) of the batteries is correct
as shown in the battery compartment.
□Place the mounting plate against the ceiling or
wall and mark the hole locations.
□If mounting to a wooden surface, install the 3
mounting screws through the mounting plate
and into the wood with a screwdriver or with a
drill and bit driver.
□If mounting to wall board or brick, drill three
pilot holes into the mounting surface using
a 7/32 inch drill bit. Insert the wall pegs
and attach the mounting plateusing the 3
mounting screws.
□Insert the main body of the light onto the
mounting plate with the tab lined up with the
UNLOCK position, and rotate the main body
CLOCKWISE until it locks into place. The tab
will now be lined up with the LOCK symbol.
The light should now be held rmly in place on
the mounting bracket.
Ceiling/Eave mount
To lock unit
to wallplate
Arrow face up
Lock unlock icon
face down
Wall mount

HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
Operation
DUSK LEARN
□Your motion sensor light is factory preset to
only work after dusk.
□You can set your own “dusk” level, which will
determine how dark it needs to be before the
motion sensor works.
□If you would like your sensor light to come on
at a different level of darkness, press the Dusk
Learn button for more than 2 seconds and
the light will ash once. Release the button
and the light will ash again after about 10
seconds and remember this light level.
□When the batteries are replaced, the sensor
light will return to the factory default setting
of 10 lux.
DIM / ECO SETTINGS
□You can set the brightness of your light to
multiple levels. This can be used to dim the
light and extend the battery life of your light.
□To adjust the dimmer setting, simply press the
dim button for more than 2 seconds until the
light comes on.
□Press the button again to dim the light in
stages. Once it reaches the dimmest level, it
will go back to the brightest level and cycle
through the dim settings. Once the button is
no longer pushed for more than 5 seconds, the
current brightness level will be set.
□When the batteries are replaced, it will return
to the factory default value.
Troubleshooting
Problem Solution
The light will not come on. □Set the DUSK LEARN at desired lux level.
□Reposition the unit within your desired detecting range.
□Recheck with new batteries.
□Recheck and make sure batteries are installed with the correct polarity
(+ & -), as shown in the battery compartment.
The light comes on during the day. □The light xture is operating normally in a dark location.
□Return the DUSK LEARN to the factory setting by removing and rein-
stalling the batteries.
The lights stay on continuously. Reposition the motion sensor away from nearby objects like a dryer vent or
a swimming pool.