DeLonghi HVF3032 User manual

De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
5711412411/04.15_00

HVF3032
FAN HEATER
Instructions for use

23
A) If your appliance comes tted with a plug, it will incorporate a 13 Amp fuse. If it does not t your socket, the plug should
be cut o from the mains lead, and an appropriate plug tted, as below.
WARNING:Very carefully dispose of the cut o plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in
the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be re-tted
when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must
NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct
replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not tted with a plug, please follow the instructions provided below:
Important
The wires in the mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red.
ELECTRICAL CONNECTION UK ONLY

3
2250 mm
600 mm
600 mm
600 mm
1
A
B
C

45
IMPORTANT SAFEGUARDS
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- The appliance must not be placed im-
mediately under a xed power socket.
- Do not use the appliance near showers,
bathtubs, sinks, swimming pools, etc.
- If the power cable is damaged, it must
be replaced by the manufacturer, an
authorised service centre or a qualied
electrician in order to eliminate all risk
see enclosed guarantee.
Important!
Failure to observe the warning could result in injury or damage
to the appliance.
-This appliance can be used by children
aged from 8 years and above and per-
sons with reduced physical, sensory
or mental capabilities or lack of ex-
perience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children shall not play with
the appliance. Cleaning and user main-
tenance shall not be made by children
without supervision.
- Children of less than 3 years should be
kept away unless continuously supervi-
sed.
- Children aged from 3 years and less
than 8 years shall only switch on/o the
appliance provided that it has been pla-
ced or installed in its intended normal
operating position and they have been
given supervision or instruction concer-
ning use of the appliance in a safe way
and understand the hazards involved.
Children aged from 3 years and less
than 8 years shall not plug in, regula-
te and clean the appliance or perform
user maintenance. CAUTION — Some
parts of this product can become
very hot and cause burns. Particu-
lar attention has to be given where
children and vulnerable people are
present.
- ATTENTION: To avoid the safety system
resetting accidentally, this appliance
must not be powered through an exter-
nal on/o device such as a timer, or
connected to a circuit which is turned
o and on regularly by the energy sup-
plier.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING: To avoid overhe-
ating, never under any cir-
cumstances cover the appliance
during operation as this would lead to a
dangerous rise in temperature.
Please note:
This symbol indicates recommendations and important
information for the user.
- Always use the appliance in an upright position.
- The use of extension leads is not recommended.
However if they cannot be avoided, follow the instruc-
tions accompanying the extension lead and never exceed
the power limit marked on the extension.
- The heater must be positioned at least 50 cm from furni-
ture or other objects.
- Do not use the appliance in rooms with a oor area of less
than 4m2.
- Before putting the appliance away, make sure it is com-
pletely o and unplugged from the mains socket.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not use the appliance to dry laundry. Do not obstruct
the air intake and outlet grilles (danger of overheating).
- Do not use the appliance near walls, furniture, curtains,
etc.
Safety functions
Safety device: the appliance is tted with a safety device
which switches it o in the event of accidental overheating

5
(e.g. obstruction of air intake and outlet grilles, motor turning
slowly or not at all). To reset, unplug the appliance from the
mains socket for a few minutes, remove the cause of overhe-
ating then plug in again. If the appliance doesn’t work please
contact the De’Longhi Customer Service.
Use in compliance with intended use
Use this heater only as described in this manual. All other use
is considered improper. This appliance is not suitable for
commercial use. The manufacturer is not liable for damage
deriving from improper use of the appliance. This is a
household appliance only. It is not intended to be used in:
• staff kitchen areas in shops, offices and other working
environments;
• farm houses;
• by clients in hotels, motels and other residential type
environments;
• bed and breakfast type environments.
Use in this manner will invalidate the manufacturers
warranty.
Disposing of the appliance
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
Fundamental recommendations regarding safety
Dear Customer – The plug on this appliance will get ‘warm’
during use, this is perfectly normal. This product is A HIGH
POWER HEATING APPLIANCE designed to our usual high
standards but please make sure your wall sockets are in good
condition and the plug is inserted correctly to avoid any
accidental overheating. We suggest that you check the plug
AND THE SOCKET regularly if the heater is in prolonged use, if
you are in any doubt please consult an electrician.
DESCRIPTION
(pag. 3)
A Thermostat
B Function selector
C Indicator light
USE
Electrical connection
- Before plugging into the mains, make sure the voltage of
your mains supply corresponds to the value V indicated
on the appliance and that the socket and power line are
appropriate for the load required.
- THIS APPLIANCE COMPLIESWITH DIRECTIVE 2004/108/EC
ON ELECTROMAGNETIC COMPATIBILITY.
Location
If the appliance is located in a room with bath or shower, re-
spect the “safety distances” shown in g. 1 and always install
away from taps, basins, showers, etc.
Functioning and use
Make sure the appliance is o before plugging into the mains.
1. Plug the appliance into the mains. The light comes on.
If your appliance has a timer, see the section “Models
with 24 hour timer”. However, to operate the appliance
without programming, move all the teeth of the timer to
the outside.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position.
4. Low power operation: turn the function selector to po-
sition 1 (in models with two fan speeds, the fan operates
at minimum).
5. Medium power operation: turn the function selector
to position 2(in models with two fan speeds, the fan
operates at maximum).
6. High power operation: turn the function selector to
position 3(the fan operates at maximum).
7. Switching o: turn the function selector to the“0”posi-
tion.
Setting the thermostat
Position the thermostat on maximum. When the room has
reached the required temperature, turn the thermostat dial
slowly anticlockwise until you hear a click and the fan goes
o. The thermostat will then keep room temperature at the
selected level automatically.
Frost prevention mode
With the function selector in position 3 and the thermostat
dial in position , the appliance maintains room tempera-
ture at about 5°C, preventing freezing with minimal energy
consumption.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the ap-
pliance.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “