接続方法[右側赤端子が(+)、左側黒端子が(ー)です]
スピーカー端子のねじをゆるめてコードの
芯線を差し込み、ねじを締めてください。
注意:スピーカーコードの芯線どうしを
接触させないでください。
■接続方法
スピーカーシステムをアンプに接続する場合は、必ずアンプの
電源を切ってからおこなってください。
・スピーカーシステム背面の入力端子(右図参照)とアンプの
スピーカー出力端子を付属の接続コードで接続します。左チ
ャンネルのスピーカーシステムはアンプのL端子へ、右チャ
ンネルのスピーカーシステムはアンプのR端子へ、極性(+、
ー)を確認して接続します。極性を間違えると、位相が変わ
ったり低音域のない不自然な再生音になってしまいます。ま
たスピーカー端子のねじが2個ともしっかり締まっているこ
とを確認してください。
CONNECTIONS
Be sure to turn the amplifier's power off when
connecting the speaker systems.
・Use the included cables to connect the input terminals
on the back of the speaker systems (see diagram) to the
amplifier's speaker output terminals. Connect the
speaker system for the left channel amplifier's "L"
terminals, the one for the right channel to the amplifier's
"R" terminals, matching the polarities ("<" and ">"
marks). Inverting the polarities will result in unnatural
sound, with the phase off or no low bass sound. Also
check that all two terminal knobs are tightly fastened.
Connections
(The red terminals on the right side are the "<" terminals, the
black ones on the left side the ">" terminals.)
NOTE : Make sure the core wires do not
touch each other.
アンプの>側へ
アンプの<側へ
Connect to amplifier's
">" side.
Connect to amplifier's "<" side.
■サランネットのはずしかた
スピーカーシステム前面のサランネットは、取り外すことがで
きます。
取り外すときは、サランネットの両側を持って手前に引いてく
ださい。
REMOVING THE SPEAKER NET
The net on the front of the speaker system is detachable.
To remove it, grasp it on both sides and pull it towards
you.
取り付けるときは、サランネットの四隅の穴部とキャビネット
の四隅の突起とを合わせて押し込んでください。
To attach the net, line up the plastic pieces holes out of the
net with the sticking in the cabinet and press in.
Loosen the terminal knobs, insert the
cables' core wires, then tighten the knobs.
INSTALLATION
The tone character produced by speaker systems
depends on such factors as the size and type of
room, the method of installation, etc. Pay attention
to the following points when installing the speaker
systems.
●If the bass sound is overemphasized when the speaker
systems are installed directly on the floor, set them on
concrete blocks or other hard stands.
●Note that howling may be produced if the speaker
systems are placed on the same stand or shelf as a
record player.
●If there are walls or glass doors behind or in front of the
speaker systems, use heavy curtains, etc., to prevent
resonance and reflection.
●This is an anti-magnet type speaker system which can be
used near television sets, etc., but with some TV sets the
colors may become blotchy. If this happens, turn off the
TV's power, wait 15 to 30 minutes, and turn the power
back on. The TV's self demagnetizing circuit will improve
the picture. If the colors are still blotchy, move the
speaker systems further away from the TV.
●Also note that if there is a magnet or any device
generating magnetic force nearby, interaction between
this device and the speaker systems can cause the colors
on the TV to become blotchy.
5