Digitus DN-95346 User manual

Outdoor 8-Port Fast Ethernet PoE
switch + 2 Gigabit SFP Uplink Ports
Quick Installation Guide
DN-95346
Introduction
The DIGITUS® outdoor PoE switch is a high quality PoE switch in a
weatherproof housing with the IP67 protection class. The housing is very
sturdy and conforms to the IK10 vandalism protection class. The PoE
switch offers a maximum range of up to 250 meters for PoE 802.3af
devices and up to 200 meters for PoE 802.3at devices with a
transmission rate of 10Mbps. When using the standard 100m range, the
transmission rate is 100Mbps. This outdoor switch serves as an all-in-one
device that is ready for use immediately after connecting it to the mains
voltage. The device requires no settings to be made thanks to plug and
play. If you you’re your PoE devices into a free PoE port, the switch will
automatically detect power supply and PoE mode. The all-in-one
solution for outdoor PoE applications requires no separate power supply
and no external overvoltage protection.

Package Content
1x PoE switch 1x Quick Installation Guide
1x T25 L-wrench
Important
1. Install the PoE switch in a ventilated and dry place that is free of
electromagnetic source, vibration, moisture, and dust.
2. Make sure the ventilation openings on the switch are not
blocked.
3. Use CAT5 or 5e UTP/STP cables.
4. AC input (100~240V/AC, 50~60Hz), for a max. consumption of
150W.
Connection
Industrial 8xFE PoE + 2xCombo GbE EXPoE Switch
VAC 100~240 power input
100-240VAC
EX Mode
OFF
ON
24 6 8 10 10
3 5 7 9 9
PWR
PoE LINK/ACT
+
-

EX MODE DIP SWITCH
EX ON Ports 1 & 2 up to 250m PoE distance. When enabled, each port
is isolated, but is linked to the uplink ports.
EX OFF Normal communication for ports 1 ~ 5
EX mode in 802.3af (15.4W):
Camera connection up to 250m@10Mbps via EXPoE ports
EX mode in 802.3at (30W):
Camera connection up to 200m@10Mbps via EXPoE ports
LED Definitions
Power Orange ON Power is on and normal
Orange Off Power is off
Link/Act Green ON Ethernet port is connected
Green Off No connection
Green blinking Data is being transmitted or received
GbE Green ON Link speed at 1000Mbps
Green Off Link speed at 10/100Mbps
PoE Orange ON Port is linked to a powered device
Orange Off No device is connected
Orange blinking Abnormal power supply is detected
Port LED1 Port LED2

Installation
Use the included M10 hex socket screws to secure the power box to a
pole-mount or corner mount bracket.
M10
3
/
4" conduit
a pole-mount or
corner mount bracket.

The mounting hole definition is illustrated below. The same mounting
hole pattern apply to all pole-mount and corner- mount brackets.
Outdoor PoE switch:
DN-95346

Important
1. If the need should arise for connecting two outdoor switches, use
the uplink ports #4 or #5. If you use PoE ports for cross-switch
connections, the 12KV surge protection will not apply.
2. The cabinet must be grounded using a ground wire between the
ground screw and earth ground.

This is a Class A product. In home environment, this product may cause radio
interference. In this case, the user may be required to take appropriate measures.
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is
part of the shipping content. If the Declaration of Conformity is missing, you can
request it by post under the below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany