Digitus WHITE WEASEL MOBILITY User manual

WHITE WEASELTM MOBILITY
3G | 4G | LTE ACCESSPOINT & ROUTER
Quick Installation Guide
Hardware Installation
A. Hardware configuration
Antenna
Reset Button
Mobile/Status LED
WAN LED
WiFi LED
LAN LED
WPS Button
Power JACK
WAN PORT
LAN PORT
USB PORT

B. Installation Steps
Note: DO NOT connect the router to power
before performing the installation steps below.
Step 1.
Plug a USB modem into USB port.
Step 2.
Insert RJ45 cable into LAN Port on the back panel of
the router. Then plug the other end of into computer.
Step 3.
Plug the power jack into the receptor on the back
panel of the router. Then plug the other end into a
wall outlet or power strip.

Getting Started with Easy Setup Utility
There are two approaches for you to set up the WiFi Combo Router quickly and easily.
One is through executing the provided Windows Easy Setup Utility on your PC, and the
other is through browsing the device web pages and configuration.
Easy Setup by Windows Utility
Step 1：
Install the Easy Setup Utility
from the provided CD then
follow the steps to configure
the device.
Step 2：
Select Language then click
“Next” to continue.
Step 3：
Then click the “Wizard” to
continue.

Step 4：
Click “Next” to continue.
Step 5：
Select Wireless Enable, and
then click “Next” to continue.
Step 6：
Enter SSID, Channel and
Security options, and then
click “Next” to continue.

Step 7：
Click” Let me select WAN
service by myself” to select
WAN service manually.
Step 8：
Select 3G Service by clicking
3G icon to continue.
Step 9-1：
Select “Auto-Detection” and
the Utility will try to detect and
configure the required 3G
service settings automatically.
Click “Next” to continue.

Step 9-2：
Or you can select “Manual”
and manually fill in the
required 3G service settings
provided by your ISP.
Click “Next” to continue.
Step 10:
Click “Next” to save
your setting.
Step 11：
The WiFi Combo Router is
rebooted to make your entire
configuration take effect.

Step 12：
Click “Next” to test the
Internet connection or
you can ignore test.
Step 13：
Click “Next” to test WAN
Networking service.
Step 14：
Setup is completed.