Digitus DN-95330 User manual

4-Port 10/100/1000 Mbps PoE Gigabit
Desktop Switch + 1xUplink
Manual
DN-95330
Product Description:
The DIGITUS Gigabit Desktop Switch with four Power over Ethernet ports and one
additional uplink Port, offers your network significant improvement in terms of per-
formance and efficiency. Thanks to PoE support, you only need a single (network)
cable for power and data transfer. This switch makes it much easier to connect de-
vices such as access points, network cameras, and IP telephones, and requires far
less cabling than alternatives. It also allows you to extend your network in places
where there are no power supply cables or sockets available: The switch does not
require any configuration and therefore guarantees quick and seamless integration
into the network. Moreover, the fanless design of the Switch en-sures soundless op-
eration, which makes this device the perfect solution for office environments and
meeting rooms.

Product Features:
•4-Port 10/100/1000 Mbps PoE Gigabit Desktop Switch + 1x Uplink Port
•Ethernet IEEE802.3 / 802.3u / 802.3x/802.3ab/ IEEE802.3 af/at
•Power over Ethernet (PoE) - You only need one cable for power and data
transfer.
•PoE power budget: 62 Watts (one to four ports)
•Supports PoE: One to four ports (802.af, 15.4 Watts)
or for two ports (802.3.at, 30 Watts)
•Maximum power output: 65 Watts
•No configuration necessary
•Status LEDs on each port
•Pin Feet: V+ (RJ45 Pin 1, 2) V- (RJ45 Pin 3, 6)
•Circuit isolation protection
•Backplane: 10Gbps
•MAC address table: 2K
•Weight: 300g
•Color: Black
•Dimensions (L x W x H): 140 mm x 95 mm x 39 mm

Package Content:
4 Port PoE switch with uplink (DN-95330)
DC Power adapter
Power cord
User’s manual
Hardware Description:
The Front Panel
The front panel consists of LED Indications.
LED Indicators
Per Device: Power
Per Port: LINK/ACT (Link/Activity)
Per PoE Port: PoE

The Real Panel
The rear panel view of the PoE switch consists of a DC power connector.
RJ-45 Ports ( Auto MDI/MDIX )
5 auto-sensing ports of 10Base-T, 100Base-TX or 1000Base-TX connections.
Port 1 to 4 can support Power over Ethernet to power devices.
Remark: MDI means connecting to another Hub or Switch while MDIX means con-
necting to a workstation or PC. Therefore, Auto MDI/MDIX means that you can con-
nect to another Switch or workstation without changing pin-to-pin or crossover ca-
bling.
DC Power Connector
Plug the female connector into the switch and male connector into a power outlet.
Support input voltages 44~57 VDC.
Product Specifications:
Item Description
Summarize
Fixed port 5x 10/100/1000Base-TX ports.
LED Indicators PWR, PoE, Link/Act LED.
Input voltage 100V～240V AC，50/60Hz (for power adapter)
48VDC (for switch)
Network Media 10BASE-TX: UTP category 5, 5e cable
100BASE-TX: UTP category 5, 5e cable
1000BASE-TX: UTP category 5, 5e cable
Forwarding Rate 10BASE-T: 14880pps / port
100BASE-TX: 148800pps / port
1000BASE-TX: 1488000pps / port
Power Supplies 65W
Operating tempera-
ture 0℃～40℃.
Storage temperature -10℃～70℃.
Relative humidity 20%～85% (non-condensing).

Thermal methods Fanless.
Switching capacity 10G.
MAC address table 2K.
Traffic control IEEE 802.3x full-duplex flow control.
Weight <1 Kg
PoE
PoE port 4 10/100/1000Base-TX ports (Port 1-4)
PoE Standard IEEE802.3af, IEEE802.3at, per port 15.4W,
max 30W
Pin assignment V+ (RJ45 Pin1, 2), V- (RJ45 Pin 3, 6).
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the re-
quirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive
2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested
by post under the below mentioned manufacturer address.
Warning:
This device is a class B product. This equipment may cause some radio interference in living
environment. In this case, the user can be requested to undertake appropriate measures to
prevent interference.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany