Directed Xpresskit dball2 User manual

Index

® Mitsubishi is a registered trademark and property of its respective company.

Vehicle Application Guide................................................................................................................................................

Installation

Type 1..............................................................................................................................................................................

Wiring Reference Chart - Type 1.....................................................................................................................................

Locating Components in the Vehicle -Type 1..................................................................................................................

Type 2..............................................................................................................................................................................

Wiring Reference Chart - Type 2.....................................................................................................................................

Locating Components in the Vehicle -Type 2..................................................................................................................

Type 3..............................................................................................................................................................................

Wiring Reference Chart - Type 3.....................................................................................................................................

Locating Components in the Vehicle -Type 3..................................................................................................................

Type 4..............................................................................................................................................................................

Wiring Reference Chart - Type 4.....................................................................................................................................

Locating Components in the Vehicle -Type 4..................................................................................................................

Programming

Module Programming......................................................................................................................................................

Module Reset & Hard Reset............................................................................................................................................

Feature and Option List...................................................................................................................................................

Feature Programming......................................................................................................................................................

LED Diagnostics and Troubleshooting............................................................................................................................

Limited One Year Consumer Warranty............................................................................................................................

Quick Reference Guide...................................................................................................................................................

Door lock and transponder interface for many of the latest models of Mitsubishi vehicles. Features

include tach output, and FOB control.

Installation Guide

Update Alert: Firmware updates are posted on the web on a regular basis. We recommend

that you check for firmware and/or install guide updates prior to installing this product.

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Vehicle Application Guide Page 2

Vehicles

2015

2014

2012

2011

2010

2009

2008

2007

2006

PK-Immobilizer Bypass-Data No Key Req'd

RS-RAP Shut Down (Retained ACC Power)

RS-Tach / RPM Output

SS-Entry Monitoring ALL Door Pins

SS-Entry Monitoring Driver Door Pin

SS-Entry Monitoring Trunk/Hatch Pin

ST-Brake Status (foot brake)

ST-E-Brake Status

ST-Ignition Status

Mitsubishi

Eclipse 3* or 4 3* or 4 3* or 4 3* or 4 3 3 3 • • • • D • • • •

Eclipse (Without OEM Alarm) 2 2 2 2 2 2 2 • • • • D • • •

Eclipse Spyder 3* or 4 3* or 4 3* or 4 3* or 4 3 3 3 • • • • D • • • •

Eclipse Spyder (Without OEM Alarm) 2 2 2 2 2 2 2 • • • • D • • •

Endeavor 3* or 4 3* or 4 3* or 4 3* or 4 3* 3* • • • • D • • •

Endeavor (Without OEM Alarm) 2 2 2 2 2 2 • • • • D • • •

Galant 3* or 4 3* or 4 3* or 4 3* or 4 3* or 4 3 3 • • • • D • • •

Galant (Without OEM Alarm) 2 2 2 2 2 2 2 • • • • D • • •

Mirage 1 1 • • • • • • • • •

Legend:

PK: Transponder & Immobilizer Override

DL: OE Door Lock & Alarm Controls

RS: Remote Start & Engine Controls

SS: Integrated Security & Monitoring

ST: Function/Feature Status

* Install Type 3 and 4: the Lock and Unlock wires must be pinned into the connector.

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Page 3

Installation Type 1

31 2

4 5 6

Remote

Starter

10: Blue/White: (-) GWR (Status) Input

Ignition Connector White

(Left side of steering column)

C-22 White 22-pin connector

(Attached to the side

of the fuse box)

(+) Parking Lights

(+) 12V

(-) Ground(-) Ground

(-) GWR (Status)

(+) Ignition Output

(-) Lock: Green, pin 22

(-) Unlock: Lt. Blue, pin 11

(-) Lock Output

(-) Unlock Output

(-) Trunk Status Input

(-) Door Status Input

(+) Brake Status Input

(-) Hood Status Input

(-) E-Brake Status Input

[1] (AC) Tach Input

C-405 White Connector

(Junction Block at driver kick panel)

Clutch Pedal

Manual Transmission ONLY

Hood

Without Anti-Theft Security Alarm Only

Hood wire must be connected to vehicle.

(+) Accessory

OR - (+) Starter

Automatic Transmission ONLY

(-) Ground

(+)12V

Prog. Button

LED

14 12 2

DBALL2 P#: XKD2D65

(+) Ignition: Green, pin 2

(+) Starter: Pink, pin 5

(+) Accessory:

Yellow, pin 4

(+) 12V:

White, pin 1 (+) Clutch: Green, pin 1

HS CAN Low: Black, pin 14

HS CAN High: Brown, pin 6

Not required in D2D mode.

[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

All adapters are displayed from the wire side (unless specified otherwise).

[1] (AC) Tach Output: Violet/White: 5

(+) Brake Status Output: Gray: 6

(-) Hood Status Output: Blue/Red: 12

(-) Door Status Output: Green/White: 3

(-) E-Brake Status Output: Black/White: 1

(-) Trunk Status Output: Red/Black: 4

CAN High: Tan/Black: 3

CAN Low: Tan: 4

(+) 12V (+) 12V: Red: 13

(-) Ground (-) Ground: Black: 14

1 8

169

22 21 1719 1520 1618 14 13 12

11 10 68 49 57 3 2 1

Diagnostic connector OBDII

(Connector side view)

2 3 4 5

11 12 138 96 7 10

(+) Parking Lights:

Green, pin 1

Refer to pages 4-5 for more information on vehicle-specific connections.

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Locating Components in the Vehicle (Type 1)

Page 4

C-22 - White Door Locks Connector

(at Driver Kick Panel, besides fuse box)

(-) Lock: Green, pin22

(-) Unlock: Lt. Blue, pin 11

Unlock:

Lt.Blue, pin 11

Lock:

Green,

pin 22

OBDII Diagnostic Connector - 16-pin Black

CAN Low: Black, pin 14

CAN High: Brown, pin 6

CAN Low:

Black

CAN High:

Brown

Function Wire Color Pin Polarity Connector Nb. Pins Conn. Color Location on vehicle

Mirage 2014-2015

Accessory 1 Yellow 4 (+) Ignition Switch 6 White Left side of Steering column

Ignition Green 2 (+) Ignition Switch 6 White Left side of Steering column

Power 12V White 1 (+) Ignition Switch 6 White Left side of Steering column

Starter Pink 5 (+) Ignition Switch 6 White Left side of Steering column

Clutch Green 1 (+) Clutch Switch 2 Gray at Clutch pedal

Parking Lights Green 1 (+) C-405 13 White Junction Block

CAN2 High Brown 6 Data OBDII connector 16 Black Drivers under dash

CAN2 Low Black 14 Data OBDII connector 16 Black Drivers under dash

Lock Green 22 (-) C-22 22 White Right of Junction Block

Unlock Lt. Blue 11 (-) C-22 22 White Right of Junction Block

Ground

Vehicle chassis

TYPE 1

Wiring Reference Chart -Type 1

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Locating Components in the Vehicle (Type 1) Page 5

Ignition Switch Connector - 6-pin White

(left side of steering column)

(+) 12V: White, pin 1

(+) Ignition: Green, pin 2

(+) Accessory: Yellow, pin 4

(+) Starter: Pink, pin 5

Accessory:

Yellow, pin 4

12V:

White, pin 1

Ignition:

Green, pin 2

Starter:

Pink, pin 5

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Page 6

31 2

4 5 6

Remote

Starter

10: Blue/White: (-) GWR (Status) Input

Ignition Connector Blue

(left side of steering column)

(-) Driver Door Trigger:

Lt. Green, pin 6

(+) 12V

(-) Ground

(+) Accessory 1

(+) Accessory 2

(+) 12V

(+) Parking Lights

(-) Ground

(-) Hood

(-) Lock Output

(-) Unlock Output

(-) Trunk Status Input

(+) Brake Status Input

(-) E-Brake Status Input

[1] (AC) Tach Input

(+) Ignition

Diagnostic connector OBDII

(Connector side view)

1 8

169

765

15 12

432 1

Junction Block

Front View

C-204 - White Connector

(Front of Junction Block

at Driver Kick Panel)

(-) GWR (Status)

1110

2019

Junction Block

Rear View

(driver kick panel)

C-219 White 24-pin Connector

(Rear of Junction Block

at Driver Kick Panel)

(-) Door Status Input

(-) Ground

(+)12V

Prog. Button

LED

14 12 2

DBALL2 P#: XKD2D65

HS CAN High: Red, pin 6 (-) Unlock:

Lt. Green/Red, pin 14

(-) Lock: Violet/White

or Violet, pin 13

HS CAN Low: Black, pin 14

(+) Ignition:

Red or Black/White,

pin 2

(+) Starter: Black/Yellow, pin 5

(+) Accessory 1:

Blue/Red, pin 4

(+) 12V:

Blue/Yellow,

pin 1

(+) Accessory 2: Blue/Black, pin 6

Not required in D2D mode.

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side.

[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

HS CAN High: Tan/Black: 3

HS CAN Low: Tan: 4

(+) 12V: Red: 13

(-) Ground: Black: 14

[1] (AC) Tach Output: Violet/White: 5

(+) Brake Status Output: Gray: 6

(-) Door Status Output: Green/White: 3

(-) E-Brake Status Output Black/White: 1:

Manual Transmission Eclipse ONLY

(-) Trunk Status Output: Red/Black: 4

(-) Auto Headlamp Shutoff Output: Green/Black: 2

Manual Transmission ONLY

(+) Starter

123 4

8 9 10 11

12 13

C-208 White connector

(Junction Block at Driver Kick Panel)

(+) Parking Lights:

Green/White, pin 2

(-) Starter

Clutch Pedal

(+) Clutch:

Brown/Black,

pin 2

86 85

87a

(+) 12V

Relay

pin 87a

Relay

pin 30

CUT

(-) Trunk Release

3: Red/White: (-) Trunk Release

Refer to pages 7-8 for more information on vehicle-specific connections.

Installation Type 2

Rev.: 20150814

Platform: DBALL2

Firmware: MIT4

Wire jump template

Wiring Reference Chart -Type 2

Function Wire Color Pin Polarity Connector Nb. Pins Conn. Color Location on vehicle

Eclipse (without OEM alarm) 2006-12

Accessory 1 Blue/Red 4 (+) Ignition Switch 6 White Left side of Steering column

Accessory 2 Blue/Black 6 (+) Ignition Switch 6 White Left side of Steering column

Ignition Red 2 (+) Ignition Switch 6 White Left side of Steering column

Power 12V Blue/Yellow 1 (+) Ignition Switch 6 White Left side of Steering column

Starter Black/Yelllow 5 (+) Ignition Switch 6 White Left side of Steering column

CAN2 High Red 6 Data OBDII connector 16 Black Drivers Under Dash

CAN2 Low Black 14 Data OBDII connector 16 Black Drivers Under Dash

Clutch Brown/Black 1 Open Clutch Switch 2 White at Clutch pedal

Parking Lights Green/White 2 (+) C-208 15 White Junction Block

Lock Violet/White 13 (-) C-219 24 White Junction Block

Unlock Lt. Green/Red 14 (-) C-219 24 White Junction Block

Door Trigger Lt. Green 6 (-) C-204 15 White Junction Block

Ground

Function Wire Color Pin Polarity Connector Nb. Pins Conn. Color Location on vehicle

Eclipse Spyder (without OEM alarm) 2006-12