Displays2go UPTSECOLB1 User manual

Assembly InstructionsAssembly Instructions
MTO LARGE BACKWALL
SKU: UPTSECOLB1

PARTS LIST
PART QUANTITY
A: Base ...................................................1
B: Backwall Panel (Left).........................1
C: Backwall Panel (Right)......................1
D. Screw 1.5in ....................................... 8
E. Wing Nut............................................ 8
F. Allen Key............................................. 1
A
E
B
C
D
F
Scan QR code to
visit product page
If you have any questions regarding our products, please visit us at www.postupstand.com
or contact customer service at 1-800-935-3534

3
2. Fold the back flap up and insert the tabs into corresponding cutouts in the middle on the base.
Note: Do not fix the bottom.
This step will be finished later.
1. Lay the base panel on a flat and clean ground. Fold up the front flap and insert tabs into the
precuts in the middle of the base panel.

4
4a. Align holes on the flaps at the center of the backwall, use screws and wing nuts to join two
backwall panels.
4b. Align holes on each side at the bottom and secure the backwall with the base by using
screws, nuts and allen key provided.
3. Expand the half backwall (Right) and fold the flaps on both sides to the back. Hold the sides with
both hands and place it in the middle groove on the base. Place the Left side backwall onto the
base the same way.
4a.
4b.

5
Eny r wEny r w
 bkw! bkw!
5. The assembly is finished. Place the backwall in desired angle and location.
CONTACT INFORMATION:
www.postupstand.com
1-800-935-3534