Displays2go Glass Display Case IFDC8040 User manual

1. Place the base (A) on the ground, insert the front glass panel (B) and 1 side glass panel (C) into grooves in the base.
Hold glass panels in place and connect them with edge bracket (G) and corner bracket (H) by using screws (J). Tighten
screws with a flat-head screw driver. Do the same for the opposite side.
CAUTION:
Be careful when handling glass!
A
PARTS LIST
A. Base
B. Glass Panel - Front
C. Glass Panel - Side
D. Glass Panel - Door
E. Glass Panel - Shelf
F. Glass panel - Top
G. Edge Bracket
H. Corner Bracket
I. Shelf Peg & Rubber Ring
J. Screw with Clear Washer
K. Aluminum Bar
L. “L” Metal Bracket
M. Door Hinge
N. Door Lock with Key
O. Glass Seal
X1
X1
X2
X2
X4
X1
X2
X2
X16
X28
X1
X2
X4
X1
X1
TOOLS NEEDED
- Flat-head Screwdriver
- Phillips Screwdriver
IMPORTANT SAFETY INFORMATION:
Read all instructions before start installing the unit. Displays2go is not responsible for any damage or injury
caused by incorrect installation, assembly or use. 3 people are recommemded for assembling.
BC D E
F
NOTE: Extra hardware is common.
I
J
G
H
K
Unpack the base box and remove parts attached inside the base (A).
Remove glass panels from the crate and identify all glass panels.
N
M
L
O
ASSEMBLY INSTRUCTIONS
Ver. 11/18
IFDC8040 - Glass Display Case - Double Door
1 of 3

2. Attach the aluminum bar (K) and 2 “L” brackets (L)
to the top glass panel (F) with screws and washers (J).
2. Attach the aluminum bar (K) and 2 “L” brackets (L)
to the top glass panel (F) with screws and washers (J).
4. Attach 1 door hinge (M) to 1 door glass panel (D),
fix the hinge at the corner. Insert the hinge collar into
the pre-drilled hole in the base.
3. Carefully place the assembled glass panel on top of the display
case. Secure the top panel by using screws and washers.
3. Carefully place the assembled glass panel on top of the display
case. Secure the top panel by using screws and washers.
5. Insert the bottom hinge into the bottom collar, and hold another
hinge with collar at the top, then slide the door panel into the top
hinge, and tighten screws to secure the door glass in place.
Assemble the other door the same way.
Tips: Test the doors and adjust as needed.
Ver. 11/18 2 of 3
IFDC8040 - Glass Display Case - Double Door

6. Fix all glass shelf pegs (I) onto the side glass panels
inside with screws and washers.
Make sure all the rubber rings in the hardware bag are
installed on the pegs.
7. Carefully place 1 glass shelf (E) on the fixed pegs at the
same level. Install the rest glass shelves the same way.
8. Install the door lock on the top of the glass door as
shown below.
Insert the glass door seal onto the edge of the glass door.
Test the lock after assembling and adjust to its best fit.
9. The assembly is finished.
Scan QR code to visit the product page:
Ver. 11/18 3 of 3
IFDC8040 - Glass Display Case - Double Door
To see assembly in action, please visit the product page at www.displays2go.com for a how-to video.
For additional support, contact D2G customer service at 844-221-3388.