Drive 11138-1 User manual

extra large heavy duty
drop arm commode
item # 11138-1
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2005 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

commode assembly
instructions and precautions
assembling commode
seat and lid:
1. Before assembling, allow toilet seat and lid to
reach room temperature if exposed to cold.
This will help prevent the seat and lid clamps
from cracking while being assembled onto
commode back frame rail.
2. Align the toilet seat clamps onto the back
frame rail. (Both clamps should sit outside
the pail brackets.) Push down on seat until
clamps snap firmly into place.
3. Slide pail in from front of commode.
1. Toilet seat must be in down position before
use. Failure to do so may result in breakage
of commode and possible injury.
2. Do NOT install commode without first
reading and understanding this assembly
and instruction sheet. If you can not
understand these instructions, contact a
healthcare, dealer or technical professional
before attempting to install. Otherwise,
injury or damage may occur.
3. Inspect all parts for shipping damage
before assembly. If there is shipping damage
- DO NOT USE. Contact dealer/carrier for
further instructions.
4. Make certain that the height adjusting
snap buttons fully protrude through the same
respective hole of each leg extension. This
will ensure that the leg extensions are
securely locked in position and an even height
is achieved (see Figure 1).
5. Ensure ALL screws, nuts and/or bolts are
tightened.
6. Check the rubber tips on the leg extensions
for rips, wear or if they are are missing.
Immediately replace any or all if any of these
imperfections exist.
7. All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
8. Users with limited physical strength should be
supervised or assisted while using commode.
additional precautions:
Figure 1
Seat Clamps
Max Weight: 850 lbs