DUSK Hattie User manual

P-1 / 5
Range Name: Hattie
Box Dimensions: L129 x W129 x H10(cm)
L51xW51xH79(cm)
Hattie Dining Table
V1.0
Up to 30 minutes
assembly time
Two persons
assembly
This product is intended for domestic use only, not for commercial purpose.

IMPORTANT
ASSEMBLY TIP
TOP TIP
SAFETY AND CARE
al
ren
HELP AND SUPPORT
RECYCLING
CARE AND MAINTENANCE
P-2 / 5
table
table
1.Do not tilt the table. Please ensure the bottom side of the leg always fully touches the floor.
2
3
4
5
6
7
8
9
10

2
Please check you have all the fittings listed below with your product.
ABCD
M8 Flat washer 7pcs
(1 extra，2 pre-attached)
M8 Spring washer 7 pcs
(1 extra, 2 pre-attached)
M8x25mm bolt 11pcs
(1 extra, 2 pre-attached)
Allen Key 1 pc
P-3 / 5
Fittings list
Parts list
Before you start to build your Hattie dining table, please take a moment to read through the instructions and make
sure that you have all the relevant parts listed on the parts checklist.
1Table Top & Support 1 pc
2Table Leg 1pc
1
1

C
D
D1 pc
1
2
P-4 / 5
C4 pcs
D1 pc
Step 1: Disassemble the support from the table top.
Please keep the bolts and washers to be used in
step 3.
Step 2: Flip over the support onto the
leg and attach the support to the leg.
Due to the weight of the item, please do
not tilt the table leg.

A6 pcs
B6 pcs
C6 pcs
D1 pc
P-5 / 5
Step 3: Carefully lift the table top onto the table leg and
from underneath. Please note all screws must be
partially screwed into the table top before tightening.
attach
Please mind your head.