Eco-Systems ECO-42C Manual

© 2022
Order #XXXXX
Locked layer contains
placeholder marks.
Counter Top
When assembled
1.5” standoff
barrels
standoff
caps
standoff
caps
1.5” standoff
barrels
4.5” standoff
barrels
Transformer
hole for wire
management To
Power
Note:
No standoff
cap for
middle
barrel.
***
Slide V20 Connector on
Standoff Barrel into groove
of horizontal extrusion.
Then turn barrel clockwise
to tighten in place.
Standoff Barrel Attachment
*
3
4
2
1
B
a
ck
er
Pa
ne
l
TOP VIEW
CEI110
bolt &
wing nut
Lights
Backer
FRONT
Item
1/2
3/4
Qty.
1/1
1/1
Description
46”w CEI110 Horizontal Extrusion
30.5”h CEI110 Vertical Extrusion
+
-
Power
Female
Transformer
96W / 4 Amp / 24V
++
--
Lights Male
Light to Light Attachment
Maximum of 7 lights per chain / 7 lights per Transformer
Light to Transformer Attachment
Steps:
1) Connect horizontals [3,4] between verticals [1,2],
sliding backer panel between verticals.
See CEI-110 Corner Connection detail.
2) Attach left & right cabinets to frame assembly [1/2/3/4]
using bolts & wing nuts.
3) Install Counter Top to assembly using standoff barrels.
See Standoff Barrel Attachment detail.
4) Connect power cords to Supernova lights as shown.
5) Apply SEG graphic to frame.
Refer to the SEG Installation general information page.
standoff
barrel
Turn to
tighten
CEI-110 Corner Connection
*1) Insert TSRV2 and A1 Brackets
into milled groove of extrusion.
2) Slide connecting extrusion
over exposed end of brackets.
3) Use Set screws to secure
extrusions.
TSRV2
Bracket
(2 pieces)
A1
Screws
*
*
*
*
ECO-42C Backlit Counter
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2022
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information