EFG 039170 User manual

EFG Mingle Sofa
Assembly Instruction 039170
For more information,
please visit www.efg.info 039170 Produced by: EFG Product development
The product contains one or more of following materials:
Metal, plastic, wood, fabric, foam.
Senast ändrad: 20170814
The wooden legs are only for single sofas, no combinations. The legs
are screwed into the holes under the sofa, one in each corner. NOTE!
Be sure to assemble the legs in the utter holes in each corner.
For EFG Mingle with the divided seat
and back, the legs look like this.

2 3
EFG Mingle Sofa assembly
For single sofas and combination ends, use the end leg and use the M8
screws.
For connecting modules use the connecting leg and the M8 screws.
Use the oval holes to tighten the modules.
End leg
M8
Connecting leg
with oval holes
Oval holes
For round corners add the smaller sledge leg and use the wooden
screws.
Small sledge leg
Wooden screw
For combinations including a straight corner there will be one direction
where the legs can´t connect the modules. This connection will be done
with bolts and nuts. Use a sharp tool (knife) and make small cuts (x2 for
each module) in the fabric where you can feel the holes in the chip-
board. Then use the bolts and nuts to connect the modules.
Find the holes and
make a small cut
for each hole
Use the bolts and
nuts to connect.