SitOnit Seating Prise Benching User manual

Table of contents

Prise Benching
Assembly Instructions
Back to back kits

Single sided kits

9



1
Peninsula kit
6

Prise Benching
Assembly Instructions (back to back)
13
TOP GLIDE SPACER
LEG
STRETCHER BRACKET
MID-BRACKET
CROSS TUBE
CABLE TRAY CLIP
EXTRUSION END CAP
DIVIDER CLAMP
CABLE TRAY
LEG RAIL
LEG RAIL COVER
TOP SUPPORT-LARGE
MIDDLE SUPPORT
DIVIDER EXTRUSION
ALLEN KEY
5/16-18 UNC SCREW
14 15 16
52
Install glides Attach divider clamps (7) to extrusion bar (14)
- BBTS kit
Assemble legs (1) to leg rail (9)
- BBEL kit
Attach cable tray clips (5)
to cable tray (8) - BBTS kit
Assemble mid-bracket (2) to
leg (1) - BBMI kit

**IMPORTANT TO USE
ALL BOLTS PROVIDED**
Attach stretcher brackets (3)
to leg rails (9)
1. 2.Connect cross tubes (4) to mid brackets (2)
& end legs.
3.Snap end covers (10) over leg rails
**DONT PUT SCREWS HERE
UNTIL TOP SUPPORTS
ARE PLACED**

Install large top supports (11) to cross tubes (4) as shown
in Fig. A
4.
Fig. A
Place middle support (12) for tops 60" & greater (no hardware, simply place on cross tube)
*tops less than 60" wide, do not use part #12
5.
Drop in cable trays (8) as shown in Fig. B
6.
Fig. B
**INSERT ONE SCREW
ON EACH SIDE OF
CROSS TUBE**

IMPORTANT TO USE
LONGER BOLTS HERE
Install extrusion (14) by attaching divider mounts to top
supports as shown in Fig. C using long bolts.
*center mount is not used on tops less than 60" wide
7.
Fig. C
Install end caps on both ends of extrusions (Fig. D)
8.
Fig. D

Prise - Sliding top installation
If using sliding top function, please follow these steps.
**please note that bases with returns & single sided setups will not allow sliding top function.
1. Each top needs 4 top glides. Insert glide through top support using the pre-drill pattern provided
in the tops. (the glides are the parts highlighted yellow in Fig. A)
2. Follow orientation in Fig. B - drill screws provided through each glide.
Fig. A Fig. B
Fig. C

If adding returns, you need the following kits:
- PRI-SSEL
- PRI-PK
*Note that sliding top function will not work with returns
Prise Benching w/ returns

Back to back typical power layout

Prise Benching
Assembly Instructions (single sided)
LEG
STRETCHER BRACKET
CROSS TUBE
WIRE BASKET
MID TOP SUPPORT
MID LEG CONNECTOR
LEG RAIL
LEG RAIL COVER
END TOP SUPPORT
ALLEN KEY
5/16-18 UNC SCREW

Install wire baskets (5) for wire management (1 or 2 per top)

Single sided typical power layout